Snapper SPLH152KW, SPLH172KW, SPA361, SPA481, SPA521, SPA611 Hours Procedure Comments

SECTION 4 - SERVICE & LUBRICATION INFORMATION

HOURS	PROCEDURE	COMMENTS
BREAK-IN	Check all fasteners for proper tightness
	Change Engine Oil and Filter at 5 hours	See engine manual
	Change Hydraulic Oil and Filter at 25 hours	Use SAE 10W-30.
		Reservoir capacity 1 Gal.
8 HOURS	Check/Change Engine Oil	Change oil if extreme dusty conditions
(Daily)	Clean Air Filter	More often if needed
	Clean Blower screen	More often if needed
	Remove Debris from under Belt Cover	More often if needed
	Sharpen Cutter Blades	Tighten Cap Screw to 70 - 80 ft. lbs.
	Grease Cutter Spindle Bearings	Use Chevron SRI Grease (NLGI2).
	Check Hydraulic Reservoir	Add oil if needed
40 HOURS	Check Tire Pressure	Add or adjust as Required
(Weekly)	Check Safety Interlock System	Inspect Switches for ease of Operation
	Grease Traction Control Levers	General Purpose Grease
	Inspect Traction Lock for Wear	Replace if Worn
	Change Engine Oil	More often if needed
	Replace Air Filter	More often if needed
	Grease Caster Wheel Bearings	General Purpose Grease
	Grease Caster Wheel Pivot	General Purpose Grease
	Grease Idler Arm Pivots	General Purpose Grease
200 HOURS	Fuel Filter	Replace with Snapper P/N 1-4359
(Monthly)	Check all Fasteners for Proper tightness	See Torque Specifications
	Change Engine Oil Filter	See Engine Manual
	Clean and Adjust Spark Plugs	See Engine Manual
	Check Belt Tension	See Operator’s Manual
	Lube Controls and Linkages	Use Medium Duty Oil
	Change Hydraulic Oil and Filter	Use SAE 10W-30 Oil.
		Reservoir capacity 1 Gal.
				GREASE		GREASE
	GREASE ZERK LOCATION			DAILY		WEEKLY
1 on the Hydro Pump Belt Idler Arm Pivot						X
1 on each Spindle Housing (Total of 2 on 36” Deck & 3 on 48”, 52”, 48”, & 61” Decks)					X
1 on each Idler Arm Pivot (Total of 1 on 36” Deck & 2 on 48”, 52”, 48”, & 61” Decks)						X
1 on each Caster Support Arm (Total of 2)						X
1 on each Caster Wheel (Total of 2)						X
1 on each Traction Control Lever (Total of 2)						X
	MAINTENANCE/REPLACEMENT PARTS
	MAINTENANCE PARTS
	36” Cutter Blade (Requires Two Blades)		2-9246
	48” Cutter Blade (Requires Three Blades)		2-9247
	52” Cutter Blade (Requires Three Blades)		2-9246
	61” Cutter Blade (Requires Three Blades)		2-9251
	36” Deck Engine to Cutting Deck Belt		2-9255
	48” Deck Engine to Cutting Deck Belt		2-9262
	48” Deck Spindle to Spindle Belt		2-9261
	52” Deck Engine to Cutting Deck Belt		2-9267
	52” Deck Spindle to Spindle Belt		2-9266
	61” Deck Engine to Cutting Deck Belt		2-9269
	61” Deck Spindle to Spindle Belt		2-9268
	Parts Manual for Pro Hydro Series 1		06926

20