SECTION 4 - SERVICE
4.2.3.HYDRAULIC PUMP BELT REMOVAL (Continued) 2. Loosen Nut on Belt Guide at rear of Engine Pulley
and remove Cutter Deck Belt from Engine Pulley. 3. Remove Hydraulic Pump Belt.
4.2.4.HYDRAULIC PUMP BELT INSTALLATION
1.STOP ENGINE! Place Hydraulic Belt on Engine and Pump Pulleys.
2.Attach Idler Spring to Bolt and reattach Nut to Bolt.
3.Place Cutter Deck Belt on Engine Pulley.
4.2.5. REPLACEMENT PARTS
To retain the quality of your Machine, use genuine SNAPPER replacement parts only. Contact your local SNAPPER Dealer for parts and service and service assistance. For the correct part or information for your Machine, always mention Model and Serial Number of Power Unit and mower Attachment. We recommend returning your Machine to an authorized SNAPPER Dealer on a yearly basis for inspection and addition of any new devices which might upgrade the performance and SAFETY of your Machine. For the nearest SNAPPER Dealer, check the yellow pages under the heading, LAWN MOWERS. For Engine Parts and Service, look for the Engine Manufacturer’s Dealers under the heading, ENGINES - GASOLINE.
WARNING
DO NOT attempt any maintenance adjustments or service with the engine running. Stop engine. Stop blades. Latch Traction Levers in neutral. Move Speed Control lever to SLOW. Remove key. Disconnect spark plug wires from spark plugs and secure wires away from spark plugs. Engine and components are HOT. Avoid serious burns, allow all parts to cool before working on machine.
NOTE: All
4.3 MACHINE SPEED CONTROL RANGES
4.3.1. TO CHANGE MACHINE SPEED RANGES
1.Move Traction Control Levers and Neutral Latch Lever into neutral.
2.Turn Key to STOP position and remove Key from Ignition Switch.
3.Remove Hairpins from Swivels on Traction Control Arms on Right and Left Hand side. See Figure 4.5.
4.Push Swivel out from each Traction Control Arm and insert Swivel into newly selected speed range. (No adjustment should be necessary to maintain neutral setting after changing speed range.) If machine does require adjustment Refer to Section
“TRACTION CONTROL NEUTRAL ADJUSTMENT”.
5.Start the Engine and resume using the Machine at the newly selected speed range.
HIGH SPEED 0 - 6 MPH
MEDIUM SPEED 0 - 4.2 MPH
SWIVEL
LOW SPEED
0 - 2.5 MPH
TRACTION
CONTROL
ROD
SELF LOCK
COTTER PIN
TRACTION CONTROL ARM
FIGURE 4.5
WARNING
The SNAPPER Pro Hydro Mowers have a Transport Speed, which allows the machine to travel forward at a speed of 6 MPH - it is NOT to be used while walking! Use the Transport Speed ONLY when the machine is equipped with a Riding Sulky! DO NOT make sharp turns at high speed! The machine has
23