SECTION 4 - SERVICE & LUBRICATION INFORMATION
TRACTION LEVERS
Lubricate each with
CONTROLS & LINKAGES
grease every 25 hours of operation.
INTERLOCK SWITCHES Inspect switches for ease of operation.
HYDRAULIC OIL
Use SAE
HYDRAULIC FILTER
Change Hydraulic Oil and Filter after first 25 hours of operation. Thereafter, change Hydraulic Oil and Filter every 200 hours (monthly).
MOTOR HUBS - Lubricate
Motor Hubs with
Compound when replacing
Wheel Hubs.
DEFLECTOR Lubricate hinge points as required.
HYDRAULIC HOSES & FITTINGS Check daily for leaks, cracks, kinks, and other signs of wear.
MOWING DECK
At end of each mowing period, remove grass and debris from under mowing deck and above rear SAFETY Shield.
Before each mowing period, coat all wear points, hinge points and sliding parts with medium duty oil.
ENGINE
Change Oil Filter after first 5 hours of operation. Change engine oil every 25 hours under normal conditions or daily under extreme dusty conditions. Change Filter every 50 hours of operation.
Clean AIR FILTER Foam Element every 25 hours. Service PAPER ELEMENT every 100 hours.
REAR TIRES - Check tire pressure before each mowing period. Inflate to
CUTTER SHAFT SPINDLES Lubricate each with two
(2) SHOTS of bearing grease daily.
CUTTER DECK
BELT(S)
Check for cracks or wear.
FRONT WHEEL BUSHINGS & CASTER SHAFTS Lubricate with bearing grease weekly.
MOWER BLADES
Check for tightness every 25 hours of operation. Tighten capscrews to 75 foot pounds.
FRONT TIRES
Check tire pressure before each mowing period. Inflate to 25 PSI.
FIGURE 4.1
19