SECTION 5 - MOWER ATTACHMENT SERVICE
5.1 CUTTER DECK BELT REMOVAL & INSTALLATION
5.1.1.36” CUTTING DECK BELT REMOVAL
1.Move Mower onto a smooth, level surface. Turn Ignition Key to STOP position, remove Key, disconnect Spark Plug Wire and secure Wire away from Spark Plug.
2.Remove Mower deck belt cover.
3.Remove Idler Tension Spring and swing Idler away from belt.
4.Remove old belt from Spindle Pulleys and Electric Clutch Pulley. See Figure 5.1.
ELECTRIC CLUTCH
REMOVE
BELTIDLER PULLEY
IDLER
TENSION
SPRING
SPINDLE
PULLEYS
FIGURE 5.1
5.1.2.36” CUTTING DECK BELT INSTALLATION
1.Route new belt to Electric Clutch Pulley.
2.Route new belt around Spindle Pulleys as shown in Figure 5.1.
3.Move Idler against belt and reattach Idler Tension Spring.
5.1.3.48”, 52”, & 61” CUTTING DECK BELT
REMOVAL
1.Move Mower onto a smooth, level surface. Turn Ignition Key to STOP position, remove Key, disconnect Spark Plug Wire and secure Wire away from Spark Plug.
2.Remove Mower deck belt cover.
3.Remove right hand Idler Tension Spring and swing Idler away from belt. See Figure 5.2.
5.1.4.48”, 52”, & 61” CUTTING DECK BELT INSTALLATION
1.Route new belt for 48” cutting deck, for 52” cutting deck, and for 61” cutting decks, to Electric Clutch Pulley.
RIGHT |
| ELECTRIC |
| |
| CLUTCH |
| ||
HAND | REMOVE BELT | LEFT | ||
| ||||
SPINDLE |
| IDLER | HAND | |
PULLEY |
| PULLEY | SPINDLE | |
|
|
| PULLEY |
RIGHT HAND | CENTER SPINDLE |
IDLER TENSION | PULLEY |
SPRING |
|
FIGURE 5.2
2.Route new belt around right and left hand Spindle Pulleys as shown in Figure 5.2.
3.Move Idler against belt and reattach right hand Idler Tension Spring.
5.1.5.SPINDLE TO SPINDLE DECK BELT REMOVAL - 48”, 52”, & 61” CUTTING DECKS
1.Move Mower onto a smooth, level surface. Turn Ignition Key to STOP position, remove Key, disconnect Spark Plug Wire and secure Wire away from Spark Plug.
2.Remove Mower deck belt cover.
3.Remove right hand Idler Spring and swing Idler away from belt.
4.Remove old belt from center and right hand Spindle Pulleys. See Figure 5.2.
5.Remove Left hand Idler Spring and swing Idler away from belt.
6.Remove old belt from left hand Spindle Pulley and center Pulley bottom groove. See Figure 5.3.
| IDLER |
| PULLEY |
REMOVE | LEFT SPINDLE |
BELT | PULLEY |
SPINDLE
PULLEY (CENTER)
LEFT
HAND
IDLER TENSION SPRING
FIGURE 5.3
24