Bogen CSUB Selecting Power Levels, Speaker Grille Installation & Removal, 70V Systems, ohmSystems

Selecting Power Levels

The front-mounted selector switch is used to set the appropriate power level or impedance for your system. Using your fingers or a flat-blade screwdriver, turn the knob until the arrow points to the power level you require.

70V Systems

A power setting scale for 70V systems is labeled on the switch. Six settings are available, from 2 to 64 watts.

8-ohm Systems

The fully counterclockwise position of the setting switch is the 8-ohm position.This set- ting is suitable for use with low-impedance amplifiers that typically support 4- or 8-ohm speakers.

Speaker Grille Installation & Removal

Installation

The speaker grille fits tightly! Push the speaker grille in until it can go no further. Then, slap around the edge of the grille to seat the grille. The grille is properly seated when it is flush with the edge of the bezel.

Note: Black butyl rubber tape is included for extra security in holding the grille in place.Cut four small pieces and space them equidistant around the groove in the baf- fle where the grille fits.The butyl rubber tape is quite sticky and it is not necessary to use an excessive amount.

Removal

Insert a pocketknife blade between the grille and the bezel about 1/4" deep and then gently pry the grille upwards. Do this in multiple places around the circumference of the grille to free the grille.

9