Installation (cont.)
SUSPENDED CEILINGS:
1. Remove the ceiling tile from the ceiling grid. Cut a
2.Put the CSUB face down on a workbench or on the floor without grille installed.
3.Place the ceiling tile over the CSUB, making
sure the ceiling tile is facing out. It is impor- tant to note the direction of the clamps: they must be installed so that they span the distance from one side of the ceiling tile to the other (approx. 24", see illustration at right). The front of the CSUB is engraved with guide arrows for “24- Inch Ceiling Tile” (see Product Diagrams section). Use these guides for this installation.
4. Using an electric powered screwdriver with the |
|
|
|
clutch at a low setting, tighten each screw |
|
|
|
until the clamps are just snug against the |
|
|
|
Support rail Mounting clamps extend | |||
tile surface. The CSUB’s clamps can be |
| to, but do not overhang, | |
tightened from either the front or rear of |
| edge of ceiling tile. | |
the speaker. Use a No. 3 Phillips screwdriv- |
|
|
|
er when working from the front. Use a 1/4"
5.Before installing the grille, make sure you have selected the proper power setting on the front panel rotary switch. Refer to the Selecting Power Levels section for instructions on selecting the power level. Install the grille as indicated in the Speaker Grille Installation & Removal section.
6.Before mounting the CSUB/tile assembly, make sure the
7.Attach the CK10 Safety Cable, if it is being used, by screwing the eyebolt into the safety tether point in the rear of the CSUB’s metal enclosure (see Product Diagrams).This may be a local code requirement. It is certainly a very good safe- ty measure, particularly in suspended ceiling installations. For more information see the instruction sheet included with the CK10.
6