Section 4 - ADJUSTMENTS & REPAIR
WARNING
DO NOT attempt any adjustments, maintenance, service or repairs with the engine running. Stop engine. Stop blade. Engage parking brake. Remove key. Remove spark plug wire from spark plug and secure away from plug. Engine and components are HOT. Avoid serious burns, allow all parts to cool before working on machine. Fuel Filler Cap and Vent must be closed securely to prevent fuel spillage.
4.2.3.MOWER DECK ADJUSTMENT
(Continued from previous page)
7.Move one side of the deck up or down to achieve levelness between both sides of deck. See Figure 4.6.
8.Tighten carriage bolt and nut securely. Recheck both sides of deck for correct levelness.
9.Readjust rear hanger chain pivots to align with holes in support brackets.
See Figure 4.7.
10.Remove angle iron, pipe, or similar object and proceed to check front to rear levelness.
4.2.4. MOWER DECK ADJUSTMENT
(Front to Rear Levelness - 25” & 28” Decks)
With the Rear Engine Rider on a smooth, level surface, rotate blade until blade tips are at front and rear of deck. Measure the distance from blade tips to floor. The distance should be the same, or the rear 1/8” lower than the front. If the rear blade tip is higher or is more than 1/8” lower than the front, proceed with adjustment.
(Front to Rear Levelness - 30” Decks)
With the Rear Engine Rider on a smooth, level surface, rotate blade until blade tips are at front and rear of deck. Measure the distance from blade tips to floor. The distance should be the same, or the rear 1/8” to 1/4” higher than the front. If the rear blade tip is higher or is more than 1/4” higher than the front, proceed with adjustment.
1.Remove rear hanger chains.
2.Turn each hanger pivot the same number of rotations on the
3.Reinstall rear hanger chains and measure blade tips again.
4.Repeat steps “1” through “3” until proper levelness is obtained.
FLOOR
FRONT
REAR
HANGER
HAIRPINCHAIN PIVOT
SUPPORT
BRACKET
HANGER
CHAIN
FIGURE 4.7
20