Snapper WM301021BE, M250821BE, M280921B, M281021BE, M300921B, M301021BE, WM280921B Introduction

Page 5

Section 1 – FAMILIARIZATION+

FUEL TANK

REAR

BUMPER

TRANSMISSION

SHIFT LEVER

OVERRIDE

LEVER

MOWER BELT

COVER

DISCHARGE

DEFLECTOR

FUEL

FILLER CAP

VENT

OPERATOR’S

SEAT

STEERING

WHEEL

ENGINE

SPEED

CONTROL

DECK LIFT

LEVER

CLUTCH/BRAKE

PEDAL

BLADE

LEVER

BLADE

PEDALS

PARK BRAKE

MOWERLATCH

DECK

FIGURE 1.1

1.1 INTRODUCTION

This manual has been prepared for the operator’s of the SNAPPER Rear Engine Rider. Its purpose, aside from recommending standard operating procedures and routine service requirements, is to promote SAFETY through the use of accepted operating practices. Read, Understand and Follow the IMPORTANT SAFETY INSTRUCTIONS on Pages 2 & 3 of this manual and All SAFETY messages on the Rear Engine Rider and its attachments before operating.

1.2 NOMENCLATURE

The nomenclature drawing above, Figure 1.1, shows the essential parts of the SNAPPER Rear Engine Rider. It is recommended that all operator’s of this equipment become thoroughly familiar with the controls, components, and operation of this machine before operating. Specific details involving the engine are found in the separate engine owner’s manual. Study these manuals before operating and keep both handy for future reference.

5

Image 5

Contents Manual No -4023 I.R /19/00 Rear Engine Riding Mower SeriesImportant Safety Instructions Operation Table of Contents Nomenclature IntroductionPRE-START Check List OPERATOR’S Seat Adjustment 2.2.1. Front to Rear AdjustmentOn Next Starting & Operation Engine Electric StartEngine Manual Start Starting & OperationEngine Electric Start Wheel Drive Starting & Operation 2.3.3. Mower BladeMower Blade Stopping ENGINE, Wheel DRIVE, Blade 2.4.1. EngineDo not park the machine on slopes Cutting Height AdjustmentStopping ENGINE, Wheel DRIVE, Blade 2.4.4. Park Brake Reverse Lockout Mechanism Override Reverse Lockout MechanismChange Engine OIL Service After First 5 HoursService Engine AIR Cleaner Check Mower Blade Service Brake / Park Brake Service After First 5 Hours 3.2.4. Check Blade Drive BeltBlade Brake Interlock SystemBattery Fluid Level Service Every 25 Operating HoursClean Mower Deck Lubrication Grease FittingsService Every 25 Operating Hours 3.3.8. Rear Axle Bearing Fuel Filter Service AnnuallyEvery TWO Years Storage OUT of SeasonMower Drive Belt Adjustment for 25, 28 & 30 M Models Engine Adjustments & RepairBlade Brake Adjustment Front to Rear Levelness 30 Decks Mower Deck AdjustmentFront to Rear Levelness 25 & 28 Decks Check fuel level in tank. If over 3/4 full, remove Wheel Brake AdjustmentFollow Warning statement found on this Blade Sharpening Mower Blade Replacement 4.4.1. Blade Wear LimitsBelt Removal Blade Drive Belt ReplacementBelt Replacement Battery Installation Battery Battery RemovalBattery Storage Battery ServiceNEW Battery Preparation 1. Remove battery from carton Battery TestingSnapper Rear Engine Rider Accessories Stop Problem Probable Cause Corrective ActionBlades Not Cutting Loss Of TractionCutting Grass ImproperlyTo be Performed Pages Subject Service ReferenceMAINTENANCE/REPLACEMENT Parts Maintenance Parts Disclaimer of Warranty Year Limited WarrantyPrimary Maintenance Primary Maintenance Primary Maintenance Primary Maintenance Rear Engine Riding Mower Series