Snapper ZM6100M, ZM2501KH, ZM5200M Cutting Height Adjustment, Stopping Machine

Page 9

Section 2 - OPERATING INSTRUCTIONS

2.3 CUTTING HEIGHT ADJUSTMENT

1.Adjust cutting height as desired to any position, using deck lift lever. See Figure 2.8.

NOTE: The engine does not have to be running to adjust cutting height.

DECK LIFT LEVER SHOWN

IN HIGH CUTTING HEIGHT

POSITION

FIGURE 2.8

2.4 OPERATION- MOTION CONTROLS 2.4.1. DRIVING MACHINE

1.Start engine. Release parking brake.

2.Move motion control (joystick) gently and with caution in desired direction:

FORWARD- Move control forward. REVERSE- Move control to the rear. LEFT TURN- Move control towards left. RIGHT TURN- Move control towards right. ZERO RADIUS TURN- Move control diagonally from neutral in desired direction. See Figure 2.9.

WARNING

DO NOT make turns at high speed. Slow machine motion. Move motion control lever gently and with caution. DO NOT make sudden changes in speed or direction.

2.4.2. STOPPING MACHINE

1.Return motion control lever (joystick) to neutral.

IMPORTANT: Operator must use hand assistance to bring motion control lever to the neutral position.

2.Engage parking brake.

3.Push blade switch in to “OFF” blades disengaged position.

4.Stop engine. Move engine speed control to turtle “SLOW” position. Turn key to stop position.

5.Remove key.

WARNING

DO NOT park the machine on slopes. DO NOT leave machine with engine running. Stop engine. Stop blades. Engage parking brake. Remove key.

REARWARD

LEFT TURN

MOVEMENT

RIGHT

TURNFORWARD MOVEMENT

FIGURE 2.9

9

Image 9
Contents Mower Unit Model Number ExplanationProtection for Children Protection Against TipoversPreparation Operation MaintenanceTable of Contents Nomenclature IntroductionPRE-START Check List Operating InstructionsStarting Engine Starting & Stopping ENGINE, BLADES, Parking BrakeFast Position Choke Stopping EngineParking Brake Cutting Height Adjustment OPERATION- Motion Controls 2.4.1. Driving MachineStopping Machine Service After First 5 Hours Change Engine OILCheck Mower Blade After Every 25 Operating Hours Check Mower Drive BeltRiding Mower Lubrication Before Operating MachineAnnually END of Each Season Deck Removal Deck Removal from previous Power Transfer Shaft RemovalSide to Side Level Neutral Position AdjustmentsFront to Rear Level Mower Deck Adjustment LevelnessParking Brake Adjustment Engine Adjustments & RepairMower Blade Replacement Blade Wear Limits Belt Replacement Mower Drive Belt ReplacementBlade Sharpening Belt RemovalBattery Battery Removal Battery InstallationBattery Service Battery Testing NEW Battery PreparationDo not Overfill Trouble Shooting on Next Problem Probable Cause Corrective ActionTractor Will Not Move Service Performed Each MAINTENANCE/REPLACEMENT Parts Mower DeckMAINTENANCE/REPLACEMENT Parts 100Disclaimer of Warranty Year Limited WarrantyPrimary Maintenance Primary Maintenance Primary Maintenance Primary Maintenance Page Page Page MID Mount Z-RIDER Zero Turning Hydro Drive Series