Parking Brake Adjustment | Snapper ZM5200M, ZM2501KH, ZM6100M

Section 4 - ADJUSTMENTS & REPAIR

WARNING

Before attempting any adjustments, maintenance, service, or repairs, stop engine and blade, always remove key from ignition switch, remove spark plug wire(s) and secure wire(s) away from spark plug(s).

4.3PARKING BRAKE ADJUSTMENT

1. The parking brake can be adjusted by removing the rod from the lever and rotating it clock-wise to increase brake tension. When properly adjusted, the parking brake lever should require 18 to 22 pounds of force to set the brake. If this adjustment does not result in proper braking action contact your authorized SNAPPER dealer for corrective action. See Figure 4.3.

4.4ENGINE ADJUSTMENTS & REPAIR

Refer to the engine owner’s manual for engine adjustments and/or repairs.

WARNING

Wear heavy leather gloves when handling or working around cutting blades. Blades are extremely sharp and can cause severe injury. DO NOT use a cutting blade that shows signs of excessive wear or damage.

4.5MOWER BLADE REPLACEMENT

4.5.1.BLADE WEAR LIMITS

1. Inspect blade frequently for signs of excessive wear or damage. See Figure 4.4.

WARNING

Do not operate this machine if the brakes are not functioning properly!

NEW BLADE

PARKING

BRAKE

LEVER WEAR LIMIT (NOTCH STARTS)

PARKING

BRAKE ROD

	DANGEROUS CONDITION!
	DO NOT USE ON MOWER!
FIGURE 4.3	REPLACE WITH NEW
	BLADE

FIGURE 4.4