Snapper ZF2101DKU, ZF5201M, ZF6101M, ZF2301GKU Introduction, Nomenclature

Page 6

Section 1 - FAMILIARIZATION

IMPORTANT

The figures and illustrations in this manual are provided for reference only and may differ from your specific model. Contact your Snapper dealer if you have questions.

OPERATOR’S SEAT

MOTION

CONTROL (JOYSTICK)

CONTROL PANEL (SEE INSET)

DECK HEIGHT OF

CUT DECAL

DISCHARGE

DEFLECTOR

FIGURE 1.1

CONTROL PANEL

 

IGNITION

AMP

BLADE SWITCH

 

METER

 

SWITCH

 

 

 

DECK

HOUR LIGHT LIFT

METER SWITCH SWITCH

FUEL TANK

PARKING BRAKE

ENGINE SPEED

CONTROL

DECK COVER

CASTER

WHEEL

BRACKET

1.1 INTRODUCTION

This manual has been prepared for the operator’s of the SNAPPER OUT FRONT Z-RIDER. Its purpose, aside from recommending standard operating procedures and routine service requirements, is to promote SAFETY through the use of accepted operating practices. Read, Understand and Follow the IMPORTANT SAFETY INSTRUCTIONS on Page 2 thru 4 of this manual and All SAFETY messages on the OUT FRONT Z-RIDER and its attachments before operating. SNAPPER recommends returning the OUT FRONT Z-RIDER to an authorized SNAPPER dealer annually for inspection and addition of any new devices which might upgrade the safety of the mower.

1.2 NOMENCLATURE

The nomenclature information above, Figure 1.1, shows the essential parts of the SNAPPER OUT FRONT Z- RIDER. It is recommended that all operator’s of this equipment become thoroughly familiar with the controls, components, and operation of this machine before operating. Specific details involving the engine are found in the separate engine owner’s manual. Study these manuals before operating and keep both handy for future reference. For the nearest SNAPPER dealer in your area, check the yellow pages under the heading LAWN MOWERS. For engine parts and service, look for the engine manufacturer’s dealers under the heading, ENGINES - gasoline.

6

Image 6
Contents OUT Front Z-RIDER Hydro Drive Series Important Safety Instructions Operation Important Safety Instructions Table of Contents Introduction NomenclatureSafety Messages and Symbols Safety Messages and Symbols Keep Children and Others OUT of the Mowing Area Operating Instructions PRE-START Check ListStarting Engine Starting & Stopping ENGINE, Blades Parking BrakeStopping Engine Starting Mower BladeStopping Mower Blade Cutting Height Adjustment Operation Motion Control 3.3.1. Driving Machine Service After First 5 Hours Change Engine OILCheck Mower Blade Check Mower Drive Belt After Every 25 Operating HoursMower Components Riding Mower Lubrication Other Lubrication PointsBefore Operating Mower Fuel Filter Diesel Engine Deck RemovalPower Transfer Shaft Removal From PreviousAdjustments & Repair Neutral Position AdjustmentsParking Brake Adjustment Mower Blade Replacement Blade Wear Limits Blade SharpeningMower Drive Belt Removal Mower Drive BELT, Engine Belt & Hydro Pump Belt ReplacementMower Drive Belt Replacement Engine Belt RemovalBattery Battery Removal Battery InstallationBattery Service NEW Battery Preparation BatteryBattery Testing Do not OverfillRemove NUT Remove Belt From Spindle Remove Blade Bolt Troubleshooting Problem Probable Cause Corrective ActionProblem Probable Cause Corrective Action Service Schedule MAINTENANCE/REPLACEMENT PartsYear Limited Warranty Disclaimer of WarrantyPrimary Maintenance Primary Maintenance Primary Maintenance Primary Maintenance Page OUT Front Z-RIDER Hydro Drive Series