Snapper 020229 owner manual Troubleshooting, Problem Cause Correction

Page 16

2450 PSI Pressure Washer

TROUBLESHOOTING

Problem

Cause

Correction

 

1.

Nozzle in low pressure mode.

1.

Pull nozzle backward for high

 

 

 

 

pressure mode.

 

2.

Water inlet is blocked.

2.

Clear inlet.

 

3.

Inadequate water supply.

3.

Provide adequate water flow.

 

4.

Inlet hose is kinked or leaking.

4.

Straighten inlet hose, patch leak.

Pump has following problems:

5.

Clogged inlet hose strainer.

5.

Check and clean inlet hose

failure to produce pressure, erratic

 

 

 

strainer.

pressure, chattering, loss of

6.

Water supply is over 100°F.

6.

Provide cooler water supply.

pressure, low water volume.

7.

High pressure hose is blocked or

7.

Clear blocks in outlet hose.

 

 

 

leaks.

 

 

 

8.

Gun leaks.

8.

Replace gun.

 

9.

Orifice is obstructed.

9.

Clean orifice.

 

10.

Pump is faulty.

10.

Contact Briggs and Stratton Power

 

 

 

 

Products service facility.

 

 

 

 

 

 

1.

Detergent siphoning tube is not

1.

Insert detergent siphoning tube

 

 

submerged.

 

into detergent.

 

2.

Chemical filter is clogged or

2.

Clean or replace filter/detergent

Detergent fails to mix with spray.

 

cracked.

 

siphoning tube.

 

3.

Dirty in-line filter.

3.

See "Check In-Line Filter".

 

4.

Nozzle is in high pressure mode.

4.

Push nozzle forward for low

 

 

 

 

pressure mode.

 

 

 

 

Engine speed is too slow.

Move throttle control to FAST

Engine runs good at no-load but

 

 

position. If engine still "bogs down",

"bogs" when load is added.

 

 

contact Briggs and Stratton service

 

 

 

facility.

 

 

 

Pressure washer stops during

Out of gasoline.

Fill fuel tank.

operation.

 

 

 

 

 

 

 

 

 

16

Image 16
Contents PSI Pressure Washer Safety Rules Table of ContentsEquipment Description When Adding Fuel Operate pressure washer only outdoorsHigh pressure spray may damage fragile items including glass Know Your Pressure Washer Siphon/FilterAssembly Carton ContentsPreparing Pressure Washer for USE Remove Pressure Washer From CartonAdd Engine Oil and Fuel Checklist Before Starting EngineConnect Hose and Water Supply to Pump HOW to USE Your Pressure Washer How to Start Pressure WasherPressure Washer Location Pressure Washer ClearanceHow to Stop Your Pressure Washer How to Use the Adjustable Nozzle Applying Detergent with the Adjustable NozzleMode Detergent application To apply detergent, follow these stepsPressure Washer Rinsing Automatic Cool Down SystemThermal Relief For RinsingPressure Washer Maintenance SpecificationsGeneral Maintenance Recommendations Purge Pump of Air Contaminants Nozzle MaintenanceCheck In-Line Filter Engine Maintenance Ring MaintenanceCleaning Chemical Injection Hose Pump MaintenanceAlways wear eye protection when using PumpSaver Preparing the Unit for StorageStoring the Engine Protecting the PumpTroubleshooting Problem Cause CorrectionSnapper Owner Warranty Policy Effective August 1 About your equipment warrantyEquipment Consumer Use Commercial Use Portable Generator Years 2nd year parts onlyTabla DE Contenidos Descripción DEL EquipoInstrucciones DE Seguridad AdvertenciaPeligro Cuando Añada CombustiblePrecaución Perilla del Cebador Usada para arranque de motores fríos Conozca SU Maquina Lavadora DE PresionCalcomanía Ejemplar de Datos no mostrado, el trasero Montaje Preparando EL Lavador a Presión Para SU USORemueva el Lavador a Presión del Empaque Contenido de la CajaAgregar Aceite al Motor y Gasolina Conecte la Manguera y el Suministro de Agua a la BombaLista de Revision Previa al Arranque del Motor Deposite la gasolina adecuada en el tanque del combustibleCómo Usar SU Lavadora a Presión Ubicación del Lavadora a PresiónCómo Darle Arranque a su Lavadora a Presión Espacio Libre Alrededor del Lavadora a PresiónCómo Usar la Boquilla Ajustable Cómo Detener su Máquina Lavadora a PresiónAplicación del Detergente Usando la Boquilla Ajustable Enjuage de la Máquina Lavadora a PresiónSistema de Enfriamiento Automático Alivio Térmico Para aplicar el detergente, siga los siguientes pasosRecomendaciones Generales EspecificacionesMantenimiento DE LA Maquina Lavadora a Presion Mantenimiento de las Boquillas Revise el Filtro en LíneaQuite boquilla la extensión del pistola de rociado Anillo ‘O’Mantenimiento DEL Motor Mantenimiento de los Anillos OLimpiando el Tubo Mantenimiento de la BombaAlmacenando EL Motor Preparando LA Unidad Para SU AlmacenamientoProteger la Bomba Reparacion DE Averias Efectiva desde el 1 ro de Agosto Equipo Para Uso Del Consumidor Para Uso ComercialGenerador Portátil Año