Snapper 020231-2 manual Add Engine Oil and Fuel, Place pressure washer on a level surface

3000 PSI Pressure Washer

2.Insert carriage bolt through holes from outside of unit and attach plastic knobs from inside of unit.Tighten by hand (Figure 2).

Figure 2 — Attach Bolts to Handle

Add Engine Oil and Fuel

• Place pressure washer on a level surface.

CAUTION

3.Place accessory tray over holes on handle (viewing from front of unit). Push the tree clips into the holes until they sit flat against the accessory tray (Figure 3).

Figure 3 — Attach Accessory Tray to Handle

Any attempt to crank or start the engine before it has been properly filled with the recommended oil will result in equipment failure.

•Refer to engine operator’s manual for oil and fuel fill information.

•Damage to equipment resulting from failure to follow this instruction will void warranty.

•Refer to engine operator’s manual and follow oil and fuel recommendations and instructions.

NOTE: Check oil often during engine break–in. Refer to engine operator’s manual for recommendations.

8