Snapper ELBX10152BV manual Front Wheel Assembly, Unit assembly

Page 5

3unit assembly

Note: Please refer to Parts List for correct part identification and placement.

FRONT WHEEL ASSEMBLY

Place Mounting Bracket against lower right corner of Blower Housing, aligning holes in bracket with threaded holes in housing. Secure with three 3/8-16 x 1 hex bolts, split lock washers and flat washers. Tighten securely.

Install Front Wheel between forks in bracket, slide sleeve through bracket and wheel, and secure with 1/2- 13 x 5” hex bolt and lock nut. Tighten snugly while allowing for free rotation of wheel.

HANDLE ASSEMBLY

The upper handles are shipped in the folded storage position. To unfold, loosen two handle knobs and rotate up to the operating position. The upper handles are secured with four knobs. Insert two 5/16-18 x 2 curved head bolts through the handles directly below the two shipping knobs. Place one internal tooth lock washer on each of the bolts. Thread knobs onto curved head bolts. Tighten all four knobs securely.

Assembly complete. Your unit is now ready to be started and checked for proper operation. Some minor final adjustments may be required; see the Maintenance portion of this manual.

5

Image 5
Contents European Extreme Series Walk-Behind Leaf Blower Congratulations PreliminariesTraining Safety rules regarding outdoor power equipmentChildren Unit assembly Front Wheel AssemblyTo Start Engine Unit operationBefore Starting Engine To Shut Engine Down Starting the EngineHints for Effective Operation General Rules to Observe Before During OperationTo Change AIR Discharge Direction Lubrication MaintenanceGeneral Unit will not Start TroubleshootingReplacement Parts AdjustmentsIllustrated parts list Qty Description Illustrated parts list Decal identification European Performance Page Page Page McDonough, GA 30253 USA