La Crosse Technology WS-9035TWC Program Mode, Programming Sequence and Default Settings

Page 5

1.Remove the battery cover. To do this, insert a solid object in the space provided at the lower-central position of the battery cover, then push up and pull out on the battery cover.

2.Observe the correct polarity, and install 3 AA batteries.

3.Replace the battery cover.

Note: Immediately after the batteries have been installed, the LCD (Liquid Crystal Display) will flash. Within 15 seconds the indoor temperature, indoor relative humidity, and the weather icons (sun and clouds) will be displayed. If not, remove batteries for 10 seconds and reinstall. If the outdoor temperature is not displayed within four minutes, remove batteries from both units, wait 30 seconds, and reinstall making sure to install batteries into the remote temperature sensor first. The time will show -:-- and start searching for the WWVB signal. If it successfully receives the time signal (usually at night), it will display the correct time (default time-zone is Eastern). You will need to adjust the time zone to match your local time.

PROGRAM MODE

Programming Note: If 30 seconds are allowed to pass, or the WIND/SNZ button is pressed during the programming mode, the unit will confirm/set the last information entered—the display will stop flashing and return to normal time-date readings. If you don’t leave the program mode during the programming of sections IV through XI, you can advance to step 4 of the next program setting. If you do leave the program setting (or want to program a specific setting) follow each instructional step to program that setting.

I.PROGRAMMING SEQUENCE AND DEFAULT SETTINGS

The programming sequence and default (factory) settings are as follows:

LCD Contrast

5

Time Zone

-5 (Eastern)

 

 

Daylight Saving Time

ON

Radio-controlled time reception

ON

 

 

12/24-hour time

12

 

 

Time – Hour

12

Time – Minute

:00

 

 

Year

2003

 

 

Month

1

Day

1

 

 

Snooze

10 minutes

 

 

Temperature Format

°F

Forecast Sensitivity

2

 

 

II.FUNCTION KEYS

The function keys are located on the front of the unit directly below the LCD (Liquid Crystal Display).

5

Page 4 Page 6
Image 5
Page 4 Page 6
Contents WS-9035TWC Table of Contents Inventory of Contents Remote TEMPERATURE/HUMIDITY Sensor Detailed SET-UP Guide Battery InstallationQuick SET-UP Guide Important Notes on Set-up and OperationII. Function Keys Program ModeProgramming Sequence and Default Settings IV. Time Zone Setting III. Setting the LCD ContrastDaylight Saving Time DST Setting VI. RADIO-CONTROLLED Time ON/OFF SettingVIII. Time Setting VII or 24 Hour Time SettingWwvb Remote Control Time Manual Time SettingSetting the Snooze IX. Setting the YEAR, DAY and MonthXII. Setting the Forecast Sensitivity XI. Selecting F or CForecast LCD Features of the WS-9035UWeather Forecast Weather IconsIV. Minimum and Maximum Temperature Records III. Outdoor Temperature and HumidityViewing the Indoor Temperature Records Viewing the Outdoor Temperature RecordsVI. Viewing the CURRENT, Maximum and Minumum DEW Point Resetting the Mimimum and Maximum RecordsMoon Phase VIII.BEAUFORT Scale Wind Speed Outdoor LCDVII. Wind SPEED, Wind CHILL, Minimum and Maximum Values Beaufort Number Or Force Wind Speed Description IX. Time Alarm Mounting with Screws Mounting Remote TEMPERATURE/HUMIDITY SensorMounting with Adhesive Tape Mounting with Nylon StrapsIII. the Indoor Weather Station TroubleshootingII. the Remote Wind Speed Sensor Maintenance and Care Instructions Power Supply SpecificationsDimensions H x W x D Weather data measuring rangeFCC Disclaimer Warranty Information
Top Page Image Contents