La Crosse Technology WS-8120U-IT, TX62U-IT specification

INITIAL SETUP (USING INCLUDED SOLAR RECHARGEABLE BATTERIES FROM THE FACTORY)

1.Open battery compartment on the back of the Weather Station and make sure that the battery switch under the battery compartment is to the left. If it is not, please slide the switch to the left before proceeding.

2.Locate the battery insulator tab and gently pull to remove it.

3.Slide the battery switch to the SOLAR position.

SWITCH LEFT

(START-UP / RESET)

(STANDARD

ALKALINES)

Slide switch to LEFT

position before (1) start- up / reset or (2) any type of battery replacement

BATTERY

COMPARTMENT

SWITCH RIGHT

(SOLAR OPERATION)

(SOLAR-RECHARGEABLE

BATTERIES)

Slide switch to RIGHT position once solar- rechargeable

batteries are inserted and insulator tab is removed

WARNING

Do NOT recharge the

included solar-

rechargeable batteries outside of this product because it will damage the batteries and other charging devices.

4.Continue to section labeled "ACTIVATE SOLAR-POWERED OUTDOOR TRANSMITTER"

ACTIVATE SOLAR-POWERED OUTDOOR TRANSMITTER

Press the RESET key on the Sensor to activate the solar-powered transmitter and place it 5-10 feet from the Weather Station for 15 minutes. The outdoor temperature will show on the weather station within 60 seconds. Allow the sensor and the weather station to sit 5-10 feet apart for 15 minutes so the signal can lock in repeatedly. Do not press buttons at this time.

NOTE: The solar panel needs light from a 60W light bulb or brighter during the activation process. Do not cover solar panel with hands or other objects.

TX62UTH-IT transmitter RESET key:

RESET key

NOTE: Do not use sharp objects to press the RESET key. Use a small dull pointed object or a straightened paper clip and gently press the RESET key to commence NORMAL MODE.

Several start up numbers will flash on the screen of the sensor then the temperature will display.