La Crosse Technology WS-7395U Detailed SET-UP Guide Battery Installation, Indoor Weather Station

Page 5

DETAILED SET-UP GUIDE

BATTERY INSTALLATION

The first step to powering up the weather station is to insert the connector (RJ11) at the end of the wire attached to the wind speed sensor to the remote temperature/humidity sensor. Please ensure when doing this that the connector is inserted with the proper orientation. When seated properly you will hear the connector ‘click’ in place.

A.REMOTE TEMPERATURE/HUMIDITY SENSOR

1.Remove the mounting bracket and humidity hood.

2.Remove the battery cover by sliding the cover down.

3.Observing the correct polarity install 2 AA batteries. The batteries will fit tightly (to avoid start-up problems make sure they do not spring free).

4.Replace the battery cover by sliding upwards. Be sure battery cover is on securely.

5.Replace the humidity hood.

B.INDOOR WEATHER STATION

1.Remove the battery cover. To do this, insert a solid object in the space provided at the lower-central position of the battery cover, then push up and pull out on the battery cover.

2.Observe the correct polarity, and install 3 AA batteries.

3.Replace the battery cover.

Note: Immediately after the batteries have been installed, the LCD (Liquid Crystal Display) will flash. Within 15 seconds the indoor temperature, indoor relative humidity, and the weather icons (sun and clouds) will be displayed. If not, remove batteries for 10 seconds and reinstall. If the outdoor temperature is not displayed within four minutes, remove batteries from both units, wait 30 seconds, and reinstall making sure to install batteries into the remote temperature sensor first. The time will show -:-- and start searching for the WWVB signal. If it successfully receives the time signal (usually at night), it will display the correct time (default time-zone is Eastern). You will need to adjust the time zone to match your local time.

5

Page 4 Page 6
Image 5
Page 4 Page 6
Contents WS-7395U Table of Contents Inventory of Contents Important Notes on Set-up and Operation Quick SET-UP GuideIndoor Weather Station Detailed SET-UP Guide Battery InstallationRemote TEMPERATURE/HUMIDITY Sensor Programming Sequence and Default Settings Program ModeIII. Setting the LCD Contrast II. Function KeysVI. RADIO-CONTROLLED Time ON/OFF Setting IV. Time Zone SettingDaylight Saving Time DST Setting VIII. Time Setting VII or 24 Hour Time SettingWwvb Remote Control Time Manual Time SettingXI. Selecting F or C IX. Setting the YEAR, DAY and MonthSetting the Snooze Features of the WS-7395U XII. Setting the Forecast SensitivityIV. Minimum and Maximum Temperature Records III. Outdoor Temperature and HumidityViewing the Indoor Temperature Records Weather ForecastResetting the Mimimum and Maximum Records Viewing the Outdoor Temperature RecordsVII. Wind SPEED, Wind CHILL, Minimum and Maximum Values Moon PhaseVI. Viewing the CURRENT, Maximum and Minumum DEW Point VIII.BEAUFORT Scale Wind Speed Mph Mounting IX. Time AlarmMounting with Nylon Straps Mounting with ScrewsMounting with Adhesive Tape III. the Indoor Weather Station II. the Remote Wind Speed SensorMaintenance and Care Instructions TroubleshootingSpecifications Weather data measuring rangeWeather data checking interval Power SupplyDimensions H x W x D FCC Disclaimer
Top Page Image Contents