La Crosse Technology 308-145B manual Power adapter, Batteries

POWER THE WEATHER STATION:

The Weather Station can be powered by the 5-volt a/c adapter or batteries.

A/C power adapter:

Insert enclosed 5-volt a/c power adapter into a wall outlet, then into the Weather Station.

Battery

Compartment

5-Volt a/c adapter

Batteries:

1.Remove battery cover: Slide tab to the right and pull out to remove battery cover.

2.Install three fresh AA batteries according to the polarity markings.

Do Not Mix Old and New Batteries

Do Not Mix Alkaline, Lithium, Standard, or Rechargeable Batteries

If the Weather Station does not display indoor temperature after 60 seconds, remove adapter and batteries, and wait for at least 60 seconds before repeating the setup process.

INSTALL BATTERIES IN THE OUTDOOR TRANSMITTER:

1.Slide the battery cover down, then lift off the back of the transmitter. Note: Be careful not to break the tabs on the battery cover.

2.Confirm the channel selector switch is on channel 1.

3.Insert two fresh AA batteries into the transmitter. Observe the correct polarity (see marking inside battery compartment).

4.Keep transmitter 5-10 ft. from the Weather Station during setup.

5.After 15 minutes, if the outdoor temperature shows on the Weather Station, you can move the outdoor transmitter outside to a shaded location within range of the Weather Station.

4