LCD Contrast Setting

Digit flashing

The LCD contrast has 8 levels, from "LCD 1" to "LCD8" (default setting is LCD 5):

1.Press the SET key, the contrast level digit will start flashing.

2.Use the + or MIN/MAX key to adjust the level of contrast.

3.Confirm with the SET key and enter the MANUAL TIME SETTING.

MANUAL TIME SETTING:

You then may manually set the time by following the steps below:

Minutes Flashing

Hour Flashing

1.The hour digit will start flashing.

2.Use the + or MIN/MAX key to set the hour.

3.Press the SET key to switch to the minutes. The minute digit will start flashing.

4.Use the + or MIN/MAX key to set the minutes (holding of the key will forward the digit by 5).

5.Confirm the time with the SET key and enter the 12/24 HOUR TIME DISPLAY SETTING.

12/24 HOUR TIME DISPLAY SETTING:

Digit flashing

The time can be set to view as 12-hour or 24-hour format. The default time display mode is “12h”. To set to “24h” time display:

1.Use the + or MIN/MAX key to toggle the value.

2.Confirm with the SET key and enter the CALENDAR SETTING.

CALENDAR SETTING:

"Month. Date." (for 12h time display) "Date. Month." (for 24h time display)

Year

The date default of the Weather Station is 1. 1. of year 2009. The date can be set manually by proceeding as follows.

1.The year digit starts flashing.

2.Use the + or MIN/MAX key to set the year (pressing and holding the key will forward the digit by 5). The range runs from "00" (2000) to "99" (2099).

3.Press the SET key to confirm the year and enter the month setting. The month digit will start flashing.

4.Use the + or MIN/MAX key to set the month.

5.Press the SET key to confirm the month and enter the date setting mode. The date digit will start flashing.

6.Use the + or MIN/MAX key to set the date.

7.Confirm all calendar settings with the SET key and enter the °C/°F TEMPERATURE UNIT SETTING.

°C/°F TEMPERATURE UNIT SETTING

Flashing

The temperature display can be selected to show temperature data in °F or °C. (Default °F)

1.The temperature unit is flashing

2.Use the + or MIN/MAX key to toggle between “°F” or “°C”.

3.Confirm with the SET key and enter the WIND SPEED UNIT SETTING

WIND SPEED UNIT SETTING

Flashing