Acu-Rite 1605 In-1 Sensor Installation Guidelines, Basic Setup is Complete, Top or Side Mount

3-in-1 Sensor Installation Guidelines

INSTALLATION HEIGHT Mount the sensor at least 5 feet (1.5 meters) off the ground (higher is better for wind measurement) in an open area. Secure to fence post, 2”x4” wood, 3/4” pole, etc. (not included)

LEVEL INSTALLATION Use a bubble level (not included) to ensure level installation for accurate wind measurement.

Top or Side Mount		Top Mount	Side Mount
1.	Insert the mounting base into the
	hole on the bottom of the sensor.
2.	Use one of the screws included
	in the hardware bag to fasten
	the lower sensor housing to the
	mounting base.

3. Fasten mounting base to a post or railing using 2 screws.

Pole Mount

1.Insert pole (we recommend 3/4” schedule 40 PVC / 25.8 mm O.D., not included) or similar item all the way into the hole on the bottom of the sensor. Note: Mounting base is not used.

2.Use one of the screws included in the hardware bag to fasten the lower sensor housing securely to the pole.

The 3-in-1 sensor is now ready to use.

Basic Setup is Complete

Pole Mount

Do not install during electrical storms. Do not place pole or sensor near electrical lines or electrical equipment.

The 3-in-1 sensor will now synchronize with the display unit. It may take a few minutes for synchronization to complete. If both or one of the units appear to be functioning improperly, please refer to the troubleshooting section.

10