Acu-Rite 00594W Accessing the Battery Compartments, Reference, Button Operation Descriptions

WIRELESS SENSOR BATTERY REPLACEMENT:

When the low battery indicator icon becomes present, it is recommended that you change the batteries. Replace only with the same or equivalent type of fresh alkaline batteries. This method of battery replacement ensures there will be no loss in MIN/MAX and history data. However, if main unit or sensors have remained without batteries for an extended period of time, the main unit will lose the MIN/MAX and all weather data recordings and will have to be synchronized again.

ACCESSING THE BATTERY COMPARTMENTS

Main Unit: Open the battery cover located on the back of the unit. Remove the screw set provided for wall mount use and insert 3 fresh “AA” batteries. (Batteries not included). Replace battery door cover.

REFERENCE

BUTTON OPERATION DESCRIPTIONS:

The main unit has 8 buttons for user operation. Please refer to the following for button operation description:

1. MIN BUTTON: Press the “MIN” button to enter the MIN MODE. The “MIN” icon on the main

unit will be displayed. Press the “EXIT” button to exit the MIN MODE. The “MIN” icon will

disappear.

2. MAX BUTTON: Press the “MAX” button to enter the MAX MODE. The “MAX” icon on the

main unit will be displayed. Press the “EXIT” button to exit the MAX MODE. The “MAX” icon will

disappear.

Thermo-Hygrometer Sensor: Rotate and pull the top casing from the bottom cone by turning the unit upside down and rotating counter-clock wise until casing pulls apart. Slide the battery compartment cover (located on the side of the sensor) off. Insert 2 fresh “AA” batteries (batteries not included). Replace the battery compartment cover and rotate the top back into the bottom piece.

Top Casing

Battery Door

Batteries

Bottom Cone

3. DISPLAY (DAILY RECORD) BUTTON: Press the “DISPLAY” button to toggle between the

following information in the upper right hand side of the main unit: WIND CHILL, HEAT INDEX,

DEW POINT.

4. CLEAR BUTTON: Press the “CLEAR” button to clear any settings currently stored in the

main unit.

5. PRESSURE SET-UP (ON/OFF/RECORD) BUTTON: Press the “PRESSURE SET-UP”

button to view the past 19 hours of recorded air pressure. Press and hold for 3 seconds to enter

the general set-up mode.

6. ALARM BUTTON: Press the “ALARM” button to stop any alarm for one day when the

alarm sounds. Press and hold for 3 seconds to enter the alarm set-up mode.

7. CHANNEL (EXIT) BUTTON: Press the “CHANNEL” button to view the outdoor tempera-

Wind Sensor: Twist off the top from the bottom and open the battery cover located on the bottom of the sensor. Insert 2 fresh “AA” batteries. (Batteries not included). Replace battery door cover by putting battery cover on half way and then sliding into place. Twist on the top to the bottom piece.

NOTE: When reinstalling the batteries while holding down the “CLEAR” button, all user settings will be cleared and the unit will set back to the factory default settings. If no button is pushed during battery replacement, the last record and user settings will be saved.

NOTE: When installing batteries, always install according to the polarity indicated in the battery compartment.

Top Casing

Battery

Battery Battery

Door

Bottom Casing

ture and humidity for any additional sensors used. Additional sensors are sold separately.

Additional sensors are optional. Press and hold the “CHANNEL” button will force the main unit

into signal searching mode.

NOTE: Pressing the “EXIT” button will exit all of the MIN/MAX, SET-UP, and ALARM settings while in these modes.

8.SNOOZE BUTTON: Press the “SNOOZE” button to enter into the snooze mode for 5 minutes when the time alarm is activated. The ALARM icon will be displayed and blinking.

NOTE: In set-up and alarm setting mode, pressing either the “MIN” or “MAX” buttons will allow the user to change any values. The user may press and hold the button for rapid scroll through of values.