Cub Cadet BB40 manual While Operating, Other Safety Warnings

Page 4

Safety (continued)

Add fuel in a clean, well-ventilated outdoor area where there are no sparks or flames. Slowly remove the fuel cap only after stopping engine. Do not smoke while fueling or mixing fuel. Wipe up any spilled fuel from the unit immediately.

Move the unit at least 50 feet (15 m) from the fueling source and site before starting the engine. Do not smoke. Keep sparks and open flames away from the area while adding fuel or operating the unit.

Never fill with fuel while the engine is running.

While Operating

Never start or run the unit inside a closed room or building. Breathing exhaust fumes can kill. Operate this unit only in a well ventilated outdoor area.

Wear safety glasses or goggles that are marked as meeting ANSI Z87.1-1989 standards. Also wear ear/hearing protection when operating this unit. Wear a face or dust mask if the operation is dusty. Long sleeve shirts are recommended.

Wear heavy, long pants, boots or safety footwear and protective gloves. Do not wear loose clothing, jewelry, short pants, sandals or go barefoot. Secure hair above shoulder level.

To reduce the risk of hearing loss associated with sound level(s), always wear ear/hearing protection when operating this unit.

Use the unit only in daylight or good artificial light.

Avoid accidental starting. Be in the starting position whenever pulling the starter rope. The operator and unit must be in a stable position while starting. See Starting/Stopping Instructions.

Do not set unit on any surface except a clean, hard area while engine is running. Debris such as gravel, sand, dust, grass, etc. could be picked up by the air intake and thrown out by the discharge opening, damaging unit, property, or causing serious injury to bystanders or operator.

Use the right tool. Only use this tool for the purpose intended.

Do not force unit. It will do the job better and with less likelihood of injury at a rate for which it was designed.

Do not overreach or use from unstable surfaces such as ladders, trees, steep slopes, rooftops, etc. Always keep proper footing and balance.

Always hold the unit with a firm grip when operating.

Keep hands, face, and feet at a distance from all moving parts. Do not touch or try to stop the impeller when it is rotating. Do not operate without guards in place.

Do not put any object into openings. Do not use with any opening blocked; keep free of dirt, debris, and anything that may reduce the air flow.

Do not touch the engine or muffler. These parts get extremely hot from operation. When turned off they remain hot for a short time.

Do not operate the engine faster than the speed needed to do the job. Do not run the engine at high speed when not in use.

Always stop the engine when operation is delayed or when walking from one location to another.

Stop the engine for maintenance or repair. The unit must be stopped and the impeller no longer turning to avoid contact with the rotating blades.

Use only original equipment manufacturer replacement parts when servicing this unit. These parts are available from your authorized service dealer. Do not use unauthorized parts, accessories, or attachments for this unit. Doing so could lead to serious injury to the user, or damage to the unit, and void your warranty.

Never use this unit for spreading chemicals, fertilizers or other substances which may contain toxic materials.

To reduce fire hazard, replace faulty muffler and spark arrestor, keep the engine and muffler free from grass, leaves, excessive grease or carbon build up.

Never point the blower in the direction of people or pets, or in the direction of windows. Always direct the blowing debris away from people, animals, and windows. Use extra caution when blowing debris near solid objects such as trees, automobiles, walls, etc.

Other Safety Warnings

Always disconnect the spark plug before performing maintenance or accessing movable parts.

Never store the unit, with fuel in the tank, inside a building where fumes may reach an open flame (pilot lights, etc.) or sparks (switches, electrical motors, etc.).

Allow the engine to cool before storing or transporting. Be sure to secure the unit while transporting.

Store the unit in a dry place, either locked up or up high to prevent unauthorized use or damage. Keep out of the reach of children.

Never douse or squirt the unit with water or any other liquid. Keep handles dry, clean, and free from debris. Clean after each use, see Cleaning and Storage instructions.

Keep these instructions. Refer to them often and use them to instruct other users. If you loan this unit to others, also loan these instructions to them.

SPECIAL NOTE: Exposure to vibrations through prolonged use of gasoline powered hand tools could cause blood vessel or nerve damage in the fingers, hands, and joints of people prone to circulation disorders or abnormal swelling. Prolonged use in cold weather has been linked to blood vessel damage in otherwise healthy people. If symptoms occur such as numbness, pain, loss of strength, change in skin color or texture, or loss of feeling in the fingers, hands or joints, discontinue use of this tool and seek medical attention. An anti-vibration system does not guarantee avoidance of these problems. Users who operate power tools on a regular basis must closely monitor their physical condition and the condition of this tool.

SAVE THESE INSTRUCTIONS

4

Image 4
Contents Back Pack Blower Table of Contents Safety Safety Warnings for Gas UnitsBefore Operating California Proposition 65 WarningOther Safety Warnings While OperatingUnit’s Protective Safety Equipment Personal EquipmentSafety and International Symbols Symbol MeaningKnow Your Unit Blower ComponentsCarton Contents Assembly InstructionsAssembling the Blower Oil and Fuel Oil and Fuel Mixing InstructionsGas Information Stroke OilUsing the Throttle OperationStarting Instructions Stopping InstructionsHolding the Blower/Vacuum Operating TipsMaintenance Daily MaintenanceWeekly Maintenance Monthly MaintenanceCarburetor MufflerCleaning the Air Filter Cooling SystemSpark Plug Air FilterSpecifications EngineLLC