Cub Cadet RZT 50 Cold Weather Starting, Using Jumper Cables to Start Engine, Stopping the Engine

Page 15

Observe the hour meter/indicator panel. If the battery indicator light or oil pressure light come on, immediately stop the engine. Have the tractor inspected by your Cub Cadet dealer.

COLD WEATHER STARTING

When starting the engine at temperatures near or below freezing, ensure the correct viscosity motor oil is used in the engine and the battery is fully charged. Start the engine as follows:

Be sure the battery is in good condition. A warm battery has much more starting capacity than a cold battery.

Use fresh winter grade fuel. Winter grade gasoline has higher volatility to improve starting. Do not use gasoline left over from summer.

Follow the previous instruction for STARTING THE ENGINE.

USING JUMPER CABLES TO START ENGINE

WARNING: Batteries contain sulfuric acid and produce explosive gasses. Make certain the area is well ventilated, wear gloves and eye protection, and avoid sparks or flames near the battery.

If the battery charge is not sufficient to crank the engine, recharge the battery. If a battery charger is unavailable and the tractor must be started, the aid of a booster battery will be necessary. Connect the booster battery as follows:

Connect the end of one cable to the disabled tractor battery’s positive terminal; then connect the other end of that cable to the booster battery’s positive terminal.

Connect one end of the other cable to the booster battery’s negative terminal; then connect the other end of that cable to the frame of the dis- abled tractor, as far from the battery as possible.

Start the disabled tractor following the normal starting instructions previously provided; then disconnect the jumper cables in the exact reverse order of their connection.

Have the tractor’s electrical system checked and repaired as soon as possible to eliminate the need for jump starting.

STOPPING THE ENGINE

Place the PTO switch in the “OFF” position.

Move the RH and LH drive control levers fully outward in the neutral position.

Engage the parking brake.

Move the throttle control to the SLOW position and allow the engine to idle for about one minute.

Turn the ignition key to the “OFF” position and remove the key from the ignition switch.

NOTE: Always remove the key from the ignition switch to prevent accidental starting or battery discharge if the equipment is left unattended.

PRACTICE OPERATION (INITIAL USE)

Operating a zero-turn tractor is not like operating a conventional type riding tractor. Although and be- cause a zero-turn tractor is more maneuverable, get- ting used to operating the control levers takes some practice.

We strongly recommend that you locate a reason- ably large, level and open "practice area" where there are no obstructions, pedestrians, or animals. You should practice operating the tractor for a minimum of 30 minutes.

Carefully move (or have moved) the tractor to the practice area. When performing the practice session, the PTO should not be engaged. While practicing, operate the tractor at approximately 1/2-3/4 throttle and at less than full speed in both forward and reverse.

Carefully practice maneuvering the tractor using the instructions in the following section "Driving the Trac- tor." Practice until you are confident that you can safely operate the tractor.

DRIVING THE TRACTOR

WARNING: Avoid sudden starts, exces- sive speed and sudden stops.

WARNING: Do not leave the seat of the tractor without disengaging the PTO, moving drive control levers fully outward in the neutral position, and engaging the parking brake. If leaving the tractor unattended, turn the ignition key off and remove key.

Adjust the operator’s seat to the most comfortable position that allows you to operate the controls. See seat adjustment in the ADJUSTMENTS section.

Release the parking brake.

15

Image 15
Contents OPERATOR’S Manual Important Read Safety Rules and Instructions CarefullyTractor Preparation Table of ContentsConnect the Battery Position Drive Control LeversLower the Deck Discharge Chute General Operation Safe Operation PracticesII. Slope Operation Do notIII. Children IV. Service Mower Deck Safety Graphic Information Graphic Safety Decals and LabelsIndicator Deck Height Indicator Park BrakeSlope Gauge Calling Service Information To the OwnerRecording Model and Serial Number Information Controls and Features Deck Height Index Ignition SwitchPower Take-Off PTO Switch Seat Adjustment Lever Not SeenThrottle Control Hour Meter/Indicator PanelHour Meter Features Indicator Panel FeaturesParking Brake Engagement Lever General SafetyOperation Choke ControlStarting the Engine Safety Interlock SystemPractice Operation Initial USE Using Jumper Cables to Start EngineCold Weather Starting Stopping the EngineTurning the Tractor While Driving Forward Driving the Tractor ForwardTurning While Driving Rearward Driving the Tractor In ReverseOperating the PTO Executing a Zero TurnStopping the Tractor Driving on SlopesChecking the Safety Interlock Circuits Using the Mower DeckAdjustments Adjusting the Operators SeatAdjusting RH & LH Drive Control Levers General Battery Information MaintenanceEngine Maintenance Hydrostatic Transmission MaintenanceServicing Electrical System Charging the BatteryBattery Maintenance Battery StorageTire Maintenance Using the Transmission Bypass RodsTractor Creeping Transmission Drive Belt Tractor High Speed TrackingEmptying the fuel system Using a fuel stabilizerTractor Storage If storing the tractor for 30 days or moreRolling the belt off the PTO pulley Mower DeckDeck Removal Releasing belt tension with the idler pulleyDeck Installation Using the idler pulley to tension the beltRolling the belt into the PTO pulley Leveling the Mower Deck Side to Side LevelingFront to Back Leveling Cleaning the Spindle Pulleys Adjusting the Gauge WheelsDeck Maintenance Using the Deck Wash SystemMower Blade Care Deck LubricationReplacing the Deck Drive Belt Page U.S.A Canada

RZT 50 specifications

The Cub Cadet RZT 50 stands out in the world of residential zero-turn mowers, offering a compelling combination of power, performance, and convenience. Designed for homeowners who prioritize both efficiency and lawn care aesthetics, the RZT 50 is an excellent choice for tackling various mowing challenges.

At the heart of the RZT 50 is a robust 24-horsepower Kohler engine. This powerful engine provides ample torque and speed, enabling users to tackle extensive lawns with ease. The mower features a 50-inch cutting deck, which can handle larger areas while maintaining a precise cut. Its unique dual-blade design ensures optimal grass clipping and minimizes the number of passes needed to achieve a well-manicured lawn.

One of the standout features of the RZT 50 is its innovative zero-turn technology. This system allows for exceptional maneuverability, enabling the mower to turn on a dime. This agility proves invaluable when navigating around trees, flower beds, and other landscaping elements, reducing the time and effort required for yard maintenance.

The RZT 50 is equipped with a Cub Cadet Endurance Series engine that enhances durability and reliability. Coupled with a rolled steel frame, this mower is built to withstand the rigors of regular use. The mower’s wide rear tires provide superior traction, allowing it to maintain stability on various terrains, from flat lawns to inclines.

Comfort is not overlooked in the RZT 50’s design. It features a high-back seat and adjustable armrests, enabling the operator to work longer without fatigue. Additionally, the soft-touch controls and easy-to-use dashboard ensure an intuitive mowing experience, even for those new to zero-turn mowers.

Maintenance is simplified with features like the easy-to-access deck washout port, which makes cleaning the mower deck a breeze. Regular upkeep is vital for keeping the mower in top condition, and Cub Cadet has made this process more user-friendly.

All these features come together to make the Cub Cadet RZT 50 a remarkable choice for homeowners. Whether you’re looking to maintain a small yard or manage a larger expanse, this mower combines power, precision, and comfort to deliver excellent results, making lawn care a task that can be completed efficiently and effortlessly.