Cub Cadet RZT 50 manual Executing a Zero Turn, Stopping the Tractor, Driving on Slopes

Page 18

Executing a Zero Turn

WARNING: When executing a zero turn, the tractor MUST BE STOPPED. Executing a zero turn while the tractor is moving can significantly reduce your control of the tractor and will cause severe turf defacement to occur.

•Stop the forward or reverse motion of the tractor by moving the two drive control levers to neutral.

•To turn clockwise, slowly move the left control lever forward while simultaneously moving the right control lever rearward. See Figure 17.

CLOCKWISE ZERO TURN

Figure 17

•To turn counterclockwise, slowly move the right control lever forward while simultaneously moving the left control lever rearward. See Figure 18.

COUNTERCLOCKWISE ZERO TURN

Figure 18

STOPPING THE TRACTOR

•Move both drive control levers to the neutral position to stop the motion of the tractor.

•Push the PTO switch downward to the disengaged position.

•Use the deck lift handle to raise the deck to its highest position.

•If dismounting the tractor, move the drive control handles fully outward in the neutral position, engage the parking brake, move the throttle control lever to the fast position, turn the ignition switch to “OFF’” and remove the key from the switch.

DRIVING ON SLOPES

Refer to the SLOPE GAUGE on page 8 to help determine slopes where you may not operate safely.

WARNING: Do not operate on inclines with a slope in excess of 15 degrees (a rise of approximately 2-1/2 feet every 10 feet). The tractor could overturn and cause serious injury.

•Always drive across slopes, never up and down. Control the speed and direction of the tractor using primarily the control lever on the downhill side of the tractor, with the uphill control lever remaining essentially in a fixed position.

•Avoid turning downhill if possible. Start at the bottom of a slope and work upward. Always slow down before turning.

•Use extra care and go slowly when turning downhill.

OPERATING THE PTO

Operate the PTO clutch as follows:

•Move the throttle control lever to approximately the mid throttle position.

•Pull the PTO switch upward to the “ENGAGED” position.

•Advance the throttle lever to the operating speed (full engine speed).

•The operator must remain in the tractor seat at all times. If the operator should leave the seat without turning off the power take-off switch, the tractor’s engine will shut off.

•The PTO clutch cannot be operated when the tractor is driving in the reverse direction. The PTO will disengage when both drive control levers are moved to the reverse position, and will re-engage when one (or both) control lever(s) is moved to the neutral or forward position.

18

Page 17 Page 19
Image 18
Page 17 Page 19
Contents Important Read Safety Rules and Instructions Carefully OPERATOR’S ManualTable of Contents Tractor PreparationConnect the Battery Position Drive Control LeversLower the Deck Discharge Chute Safe Operation Practices General OperationII. Slope Operation Do notIII. Children IV. Service Deck Height Indicator Park Brake Safety Decals and LabelsIndicator Mower Deck Safety Graphic Information GraphicSlope Gauge Calling Service Information To the OwnerRecording Model and Serial Number Information Controls and Features Seat Adjustment Lever Not Seen Ignition SwitchPower Take-Off PTO Switch Deck Height IndexIndicator Panel Features Hour Meter/Indicator PanelHour Meter Features Throttle ControlChoke Control General SafetyOperation Parking Brake Engagement LeverSafety Interlock System Starting the EngineStopping the Engine Using Jumper Cables to Start EngineCold Weather Starting Practice Operation Initial USEDriving the Tractor Forward Turning the Tractor While Driving ForwardDriving the Tractor In Reverse Turning While Driving RearwardDriving on Slopes Executing a Zero TurnStopping the Tractor Operating the PTOUsing the Mower Deck Checking the Safety Interlock CircuitsAdjustments Adjusting the Operators SeatAdjusting RH & LH Drive Control Levers Hydrostatic Transmission Maintenance MaintenanceEngine Maintenance General Battery InformationBattery Storage Charging the BatteryBattery Maintenance Servicing Electrical SystemTire Maintenance Using the Transmission Bypass RodsTractor Creeping Tractor High Speed Tracking Transmission Drive BeltIf storing the tractor for 30 days or more Using a fuel stabilizerTractor Storage Emptying the fuel systemReleasing belt tension with the idler pulley Mower DeckDeck Removal Rolling the belt off the PTO pulleyDeck Installation Using the idler pulley to tension the beltRolling the belt into the PTO pulley Leveling the Mower Deck Side to Side LevelingFront to Back Leveling Using the Deck Wash System Adjusting the Gauge WheelsDeck Maintenance Cleaning the Spindle PulleysMower Blade Care Deck LubricationReplacing the Deck Drive Belt Page U.S.A Canada

RZT 50 specifications

The Cub Cadet RZT 50 stands out in the world of residential zero-turn mowers, offering a compelling combination of power, performance, and convenience. Designed for homeowners who prioritize both efficiency and lawn care aesthetics, the RZT 50 is an excellent choice for tackling various mowing challenges.

At the heart of the RZT 50 is a robust 24-horsepower Kohler engine. This powerful engine provides ample torque and speed, enabling users to tackle extensive lawns with ease. The mower features a 50-inch cutting deck, which can handle larger areas while maintaining a precise cut. Its unique dual-blade design ensures optimal grass clipping and minimizes the number of passes needed to achieve a well-manicured lawn.

One of the standout features of the RZT 50 is its innovative zero-turn technology. This system allows for exceptional maneuverability, enabling the mower to turn on a dime. This agility proves invaluable when navigating around trees, flower beds, and other landscaping elements, reducing the time and effort required for yard maintenance.

The RZT 50 is equipped with a Cub Cadet Endurance Series engine that enhances durability and reliability. Coupled with a rolled steel frame, this mower is built to withstand the rigors of regular use. The mower’s wide rear tires provide superior traction, allowing it to maintain stability on various terrains, from flat lawns to inclines.

Comfort is not overlooked in the RZT 50’s design. It features a high-back seat and adjustable armrests, enabling the operator to work longer without fatigue. Additionally, the soft-touch controls and easy-to-use dashboard ensure an intuitive mowing experience, even for those new to zero-turn mowers.

Maintenance is simplified with features like the easy-to-access deck washout port, which makes cleaning the mower deck a breeze. Regular upkeep is vital for keeping the mower in top condition, and Cub Cadet has made this process more user-friendly.

All these features come together to make the Cub Cadet RZT 50 a remarkable choice for homeowners. Whether you’re looking to maintain a small yard or manage a larger expanse, this mower combines power, precision, and comfort to deliver excellent results, making lawn care a task that can be completed efficiently and effortlessly.
Top Page Image Contents