Cub Cadet 3165 manual Turning Radius Adjustment, Maintenance Chart

•With the brake pedal disengaged, insert an .030” feeler gauge between the inner brake pad and the rotor. If the .030” gauge does not fit, the brakes are overly tightened and should be loosened.

•Attempt to insert an .060” feeler gauge between the inner brake pad and the rotor. The .060” clearance is maximum allowable clearance and insertion of the gauge should not be possible.

•If the .060” gauge can be inserted the brake must be tightened.

•Accessing the brake adjustment nut from the rear of the tractor, beneath the fender, turn the nut clockwise to

tighten and counterclockwise to loosen the brake assembly. See Fig- ure 15.

•Turn the adjustment nut as neces- sary to obtain the .030” to .060” clearance.

•Repeat the above procedure to check and adjust the other brake assembly as necessary.

Turning Radius Adjustment

This tractor is equipped with power assisted steering which is set at the factory. The turning radius should be equal for both left and right hand turns. If adjustment is necessary please con- tact your authorized Cub Cadet dealer.

SECTION 9: MAINTENANCE

Maintenance Chart

	Each Use	50 Hours	100 Hours	150 Hours	200 Hours	250 Hours	300 Hours
Grease front wheel bearings	•
Grease L/R steering knuckles	•
Grease front pivot axle	•
Check engine oil level	•
Change engine oil and filter	‡	•	•	•	•	•	•
Check transmission oil level	•
Change transmission oil filter			•	•	•	•	•
Change transmission oil				•		•
Check air cleaner & housing	•
Clean & re-oil foam air	††
pre-cleaner
Change air cleaner			†		†		†
paper cartride

‡Change oil and filter after first 8 hours

† More often under dusty conditions

††Clean every 25 hours or more often under dusty or dirty conditions

17