Cub Cadet 3654, 3660 Initial Adjustments and Service, Check the fluid levels and tires

Page 9

to the left then push the seat forward or back to the desired posi- tion. Release the lever so the seat will lock in place.

9.Digital Tachometer and Hour Meter: (See Figure 1) Located on the right side of the mower of the ignition switch. When the machine is running the tachometer displays engine rpm. When the machine is off the tachometer displays running time.

Note: There will be a flashing “LUBE” for each recommended lubrication interval.

There is a flashing “OIL” at each recommended engine oil and filter change. Flashing of “Lube” or “Oil” will continue for 1 hour regardless of maintenance done to the unit.

10.Choke Lever: (See Figure 2) The Choke Lever is located on the left instrument panel next to the seat. The Choke Lever is operated manually. Having the Choke Lever in the ON position helps the engine to start during initial start-up. During normal operation the Choke Lever should be in the OFF position.

B.Initial Adjustments and Service

1.Check the fluid levels and tires:

Note: These checks should be made daily, before starting the engine.

a.Fuel: Using a good grade of unleaded, regular gasoline (for a gasoline engine), fill the fuel tank (beside the engine on the left or right side of the mower). When the fuel reaches one inch from the top of the tank, stop. DO NOT OVER- FILL. Space must be left for expansion.

b.Engine Oil: (Filled at the factory before shipment.) Pull out the oil dipstick, wipe it off and reinsert it. Pull it out again and read the oil level. If it is below the operating range, add oil through the fill tube using a funnel to bring it up to the top of the operating range.

Note: Gasoline Engine: Use SAE 10W30 or SAE 10W40 engine oil, rated for ser-

vice SJ.

c.Hydraulic Oil: (Filled at the factory before shipment.) The hydraulic oil tank is located beneath the operator’s seat. Always wipe off the area around the oil tank fill neck before checking the oil level to prevent dirt from contaminating the oil. Remove the cap and make sure the oil level is up to the lowest hole on the oil tank fill neck. The top hole is for vent- ing. If the oil level is low, fill with a good grade of SAE20W- 50 oil.

d.Tires: 8-10 psi Rear, 25-30 psi Front Caster Tires

9

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Commercial Riding Mower Table of Contents Forward Safety Precautions GeneralRelated to Fuel When Mowing Specifications Controls Operating InstructionsSeat Adjustment Lever The Seat Check the fluid levels and tires Initial Adjustments and ServiceAdjust the Mowing Deck Proper Angle or Pitch Leveling the Deck Side to Side Start the Engine Break-In And OperationPage Mower Deck Maintenance and ServiceParking the Mower Removing the Mower DeckSharpening a Blade Changing a BladeChanging the Blade Drive Belts Changing the Spindle Assembly Stop the engine and remove the key from the ignition switchHydraulic Oil Draining Hydraulic Oil Electrical CircuitBattery Removal Installing the BatterySpecific Freezing Gravity Temp F Jump Starting Page Inflation Pressure TiresBrakes Hydraulic Oil Tank and Filter Hydraulic SystemRemoving the cap to prevent dirt from contaminating the oil Page Storage To Put the Mower Back in ServiceDaily Checks Maintenance ScheduleEvery 25 Hour Checks Weekly or Every 50 Hour ChecksOil wear points. Follow the Oiling Chart Every 100 Hour ChecksYearly Checks Lubrication Chart Wiring Diagram Equipment TWO-YEAR Limited Warranty
Top Page Image Contents