ASSEMBLY
WARNING:
Stop the engine and disconnect the spark plug wire before installing parts, making adjustments, cleaning, or when not in use. Failure to do so could result in possible serious personal injury.
INSTALLING THE VACUUM TUBES
See Figures 5 and 6.
To install the vacuum tubes:
1.Screw the upper and lower vacuum tubes together and tighten securely.
2.Loosen the door knob on the inlet cover door and open. Place the notch in the support arm of the upper vacuum tube under the hinge of the inlet cover door.
3.Push the upper vacuum tube into the blower housing.
4.Align the upper vacuum tube knob with the hole in the housing and tighten securely.
To remove the vacuum tubes:
1.Loosen the upper vacuum tube knob.
2.Remove the vacuum tubes from the blower housing.
3.Close the inlet cover door and tighten the door knob securely.
INLET COVER
DOOR
DOOR KNOB
Fig. 5
HINGE
UPPER
NOTCH IN
SUPPORT ARM
VACUUM
TUBE KNOB
Fig. 6
Page 10