TROUBLESHOOTING
IFTHESE SOLUTIONS DO NOT SOLVETHE PROBLEM CONTACTYOUR AUTHORIZED SERVICING DEALER.
PROBLEM | POSSIBLE CAUSE | SOLUTION |
|
|
|
Engine will not start: | 1.No spark. |
2.No fuel.
3.Flooded engine.
4.Starter rope pulls harder now than when new.
1.Check spark. Remove spark plug. Reattach the spark plug cap and lay spark plug on metal cylinder. Pull the starter rope and watch for spark at spark plug tip. If there is no spark, repeat test with a new spark plug.
2.Push primer bulb until bulb until fuel is visible in the bulb. If fuel is not apparent, the primary fuel delivery system is blocked. Contact a servicing dealer. If primer bulb fills, engine may be flooded (see next item).
3.Remove spark plug, turn blower so spark plug hole is aimed at the ground. Move choke lever to “RUN” and pull starter cord 10 to 15 times. This will clear excess fuel from engine. Clean and reinstall spark plug. Pull starter three times with choke lever at “RUN”. If engine does not start, move choke lever to “CHOKE” and repeat normal starting procedure. If engine still fails to start, repeat procedure with a new spark plug.
4.Contact a servicing dealer.
Engine starts but will not accel- | Carburetor requires adjustment. | Turn "L" needle counterclockwise 1/16 turn. If “L” | ||
erate: |
| low needle can not be turned counterclockwise, do | ||
|
|
| not force plastic limiter caps. Contact a servicing | |
|
|
| dealer. See Figure 14. | |
|
|
|
|
|
Engine starts but will only run | Carburetor requires adjustment. | Turn "H" needle counterclockwise 1/16 turn. If “H” | ||
at high speed at half choke: |
| high needle can not be turned counterclockwise, do | ||
|
|
| not force plastic limiter caps. Contact a servicing | |
|
|
| dealer. See Figure 14. | |
Engine does not reach full speed and emits excessive smoke:
1.Oil / fuel mixture is incorrect.
2.Air filter is dirty.
3.Carburetor requires adjustment.
4.Spark arrestor screen is dirty.
1.Use fresh fuel and the correct
2.Clean air filter, refer to “Replacing and Cleaning the Air Filter” earlier in this manual.
3.Turn “H” (B) needle clockwise 1/16 turn. See Fig- ure 14.
4.Contact a servicing dealer.
Engine starts, runs, and accel- | Carburetor requires adjustment. | Turn idle speed screw clockwise to increase idle |
erates but will not idle: |
| speed. See Figure 14. |
|
|
|
NOTE: The carburetor adjustment needle(s) are equipped with plastic cap(s) that prevents counterclockwise rotation from the original factory adjustment. If your unit exhibits specific performance problem(s) where the Trouble Shooting Section recommends a counterclockwise needle adjustment and no adjustments have been made since original pur- chase, the unit should be taken to a factory authorized service dealer for repair. In most cases, the needed adjust- ment is a simple task for the factory trained service repre- sentative.
| “L” NEEDLE |
| “H” NEEDLE |
IDLE SPEED | Fig. 14 |
ADJUSTMENT SCREW |
Page 16