Bolens 769-00407 manual To Empty BAG, To Remove Blower Chute, Using the Nozzle Vacuum

Page 10

When temperature is below 32 degrees F:

Move throttle control / choke lever on engine to CHOKE position. (A warm engine may not require choking.) See Figure 8.

If not using choke to start engine, move throt- tle control / choke lever to START/RUN posi- tion.

Depress the primer bulb firmly with your thumb three times. Wait about two seconds between each push.

NOTE: See air cleaner on side of engine for further starting instructions.

Throttle Control/

Choke Lever

Primer

Buttons

 

Inner Flap

Bag

Clip

 

Bag Handle

 

Outer Flap

 

Strap

 

Figure 9

Figure 8

6.Standing behind the unit, grasp starter handle and pull rope out until you feel a drag.

7.Pull the rope with a rapid, continuous, full arm stroke. Keep a firm grip on the starter handle. Let the rope rewind slowly.

8.Repeat, if necessary, until engine starts. When engine starts, move throttle /choke lever gradu- ally to START/RUN position.

9.If engine falters, move control lever to CHOKE position, then back to START/RUN position.

10.ALWAYS keep the throttle control in the START/ RUN position when operating the Yard Vacuum.

TO EMPTY BAG

Unhook bag straps from the lower handle and unsnap bag clip from top of the lower handle. See Figure 9.

Grasp bag handle with one hand and pull lock rod on mounting bracket with other hand toward engine to release.

Remove bag from over the rim of the discharge opening. Refer to Figure 4.

Twist the two buttons on the back of the bag to unlock and empty contents. See Figure 9.

Hold bag handle and bag clip while emptying the contents.

Compress bag opening and fold inner flap over opening.

Fold outer flap over inner flap and insert buttons on the bag through metal outlets.

Twist the buttons to lock bag.

TO REMOVE BLOWER CHUTE

Grasp blower chute with one hand and pull lock rod on mounting bracket with other hand toward engine to release. Refer to Figure 6.

Remove blower chute from over the rim of the discharge opening.

Using the Nozzle Vacuum

Place nozzle/hose vac handle in the top position on the nozzle to vacuum through nozzle. See Figure 10.

The spring loaded pin must be in the first hole of the hose adapter to operate the nozzle vac.

Place both hands on top of upper handle to push unit over yard waste.

Yard waste such as leaves and pine needles can be vacuumed up through the nozzle for shredding. After material has been shredded by the flail blades on the impeller assembly, it will be discharged into catcher bag or through blower chute. Do not attempt to shred or chip any material other than vegetation found in a normal yard (i.e. branches, leaves, twigs, etc.) Avoid fibrous plants such as tomato vines until they are thoroughly dried out. Materials such as stalks or heavy branches up to 1 1/2” in diameter may be fed into the chipper chute.

WARNING: Do not attempt to shred, chip, or vacuum any material larger than specified on the machine or in this manual. Personal injury or damage to the machine could result.

10

Image 10
Contents Yard Vacuum Table of Contents WarrantyTraining SafetyPreparation Maintenance and Storage OperationRemoving Unit from Carton Disconnecting Spark PlugAssembly Loose Parts in Carton See FigureAttaching the BAG Attaching The Hose AssemblyAttaching the Blower Chute Front Tab Locking Rod Nozzle Bag Nozzle Height Adjustment LeverChipper Chute Throttle Control / Choke LeverTo Stop Engine GAS and OIL FILL-UPTo Start Engine To Empty BAG Using the Nozzle VacuumWhen temperature is below 32 degrees F To Remove Blower ChuteUsing the Hose Assembly Nozzle Height AdjustmentCheck Engine OIL Clean EquipmentGeneral Recommendations LubricationService Muffler Service AIR CleanerService Spark Plug Clean EngineEngine Speed Carburetor AdjustmentService and Adjustments Removing the Flail ScreenDisconnect and ground the spark plug wire Sharpening or Replacing Chipper BladeOther Yard VacuumEngine StorageTroubleshooting Problem Possible Causes Corrective ActionParts List Part Description Part DescriptionSears Craftsman 6.0 H.P. Yard Vacuum Model Polo Green Oyster Grey Powder Black 12H800 Choke System 968 425 425A 968B 966A 159 972 972A 957 930 1040 1059 972D 930C Emission Label 332 356 333 493279 493260399269 49336520A 499429499425 691092497465 499423691997 K272199133 398187 117 494870125 498170 134 D398188209B 691851 209 691864209A 690567 305 691108 217 690354276 Dz271716 222 692031689 691855 445A 491588601 95162 455 695161870 690380 Switch801 690782 923 6919941059 692311 970 6916691019 494256 1036 695111Contenido GarantiaOperacion EN General SeguridadNiños ServicioDesconexion DE LA Bujia DesembalajePiezas Sueltas Instalacion DEL ManillarChaveta Tuercas dePasador Soplador Tolva deEtiqueta Barra Delantera Cierre de Boquilla Controles DE OperacionTubo de astillado RecolectorGasolina Para Apagar EL MotorCuando la temperatura es sobre 32F 0C Para Arrancar EL MotorDescarga de la bolsa Cuando la temperatura esta por debajo de 32F 0CUso del montaje de la manguera Extracción del canal de sopladoUso del pico de la aspiradora Ajuste de la altura del picoRevision DEL Aceite DEL Motor LubricacionLimpieza DEL Equipo Cambio DE Aceite DEL MotorServicio DE LA Bujia Para Vaciar EL AceiteServicio DEL Filtro DE Aire Servicio DEL SilenciadorRetiro DE LA Rejilla DE Flagelos Ajuste DEL CarburadorVelocidad DEL Motor Servicio Y AjustesCuchilla CarcasaSuperior AstilladoraOtros Aspiradora para jardinesMotor AlmacenamientoProblema Causas posibles Solución Localizacion DE Averias