Briggs & Stratton 37610701 - 04 owner manual Impeller Blade Replacement

ASSEMBLY

STEP 3:	A
Slide Engine Mount Arm (B) into the receiver
on the Mount Plate (A) and fasten by
dropping in ball pin (#J0248). Place Engine/
Blower Assembly onto Engine Mount Arm (B)
and fasten with (4) 5/16"-18 x 1 1/2 hex bolts
(#K1157) and (4) 5/16"-18 flange nuts. Tighten
nuts and bolts.

STEP 4:

The ears of the Cone (A) should fit underneath the two threaded bosses on the Blower Face (B). Secure with (2) 5/16"-18 x 2" cone bolts.

TIGHTEN CONE BOLTS BEFORE EACH USE! B

B

A

Impeller Blade Replacement

To remove: Remove hex bolts from hub then screw the bolts

into threaded holes to remove old blade.	B
(This will push the impeller off the hub.) If the A
impeller is stuck on hit the base of the impeller
between each vein with a hammer then try the
bolts again.

To replace: Place tapered bushing (A) into hub (B) and align non-threaded holes with the holes in the hub.

Secure with two 1/4" x 1" hex bolts. Torque to 15 ft. lbs.

MODEL 37610701 - 04 PeCo 5