Safety Instructions
Operating Instructions
Troubleshooting Tips
Consumer Support
Before you call for service…
NOISE | Possible Causes | What To Do | |
Washer is noisy | Washer is uneven | • To level the front of the washer, adjust the front leveling | |
|
|
| legs by rotating the individual leg in the proper direction |
|
|
| for up or down. To level back of washer, lift back of |
|
|
| machine 4″ (11 cm) and set down. |
|
|
|
|
|
| Washer load is | • Press START to pause the washer, open the lid and |
|
| unbalanced | redistribute the load evenly. Close the lid and press |
|
|
| START again. |
|
|
|
|
|
| Shipping rod is still assembled | • To remove shipping rod from washer, pull yellow tag and |
|
| in unit | attached rod from the bottom right hand side of washer. |
|
|
|
|
|
| Washer is sitting too close | • Pull washer away from the wall; about 4″ (11 cm) |
|
| to wall (causes knocking | is needed. |
|
| during cycle) |
|
|
|
|
|
|
| PerfecTemp Plus feature | • This is normal. PerfecTemp Plus turns water valves off |
|
| is being used | and on to adjust water temperature. |
|
|
| |
OTHER | Possible Causes | What To Do | |
|
|
| |
Labels on the exterior | Occasionally the adhesive | • Use a hair dryer set at the lowest heat setting, directing | |
of the washer will not | used on the labels does | the air at the label for a short amount of time. This will | |
peel off cleanly | not release cleanly | release the adhesive easily, without damaging the surface | |
|
|
| of the washer. |
18