Metering Valve (18) and Air Input Valve (14) to the “OFF” position. Use the Safety Valve (6) to release any remaining air pressure in the Tank Assembly (3). Check to make sure the Pressure Gauge reads “0” PSI. Then, disconnect the compressor air hose from the Quick Connector on the Pressure Blasting System.
2.Before each use, inspect the general condition of the Pressure Blasting System and its accessories. Check for loose screws, misalignment or binding of moving parts, cracked or broken parts, damaged air hoses, and any other condition that may affect safe operation. If abnormal noise or vibration occurs, have the problem corrected before further use. Do not use damaged equipment.
3.Before, during, and after use: Periodically, check the Water Trap (12) for excessive water
(See Figure G.)
4.To clean the exterior of the Pressure Blasting System, wipe with a clean, damp cloth using a mild detergent or mild solvent. Do not immerse the tool in liquids.
5.When storing, always store the Pressure Blasting System in a clean, dry, safe location out of reach of children and other unauthorized people.
6.
CAUTION! All maintenance, service, and repairs not mentioned in this manual must only be performed by a qualified service technician.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISKS AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
SKU 93889 For technical questions, please call | PAGE 13 |