WARNING
HIGH PRESSURE SPRAY CAN CAUSE SERIOUS INJURY
FOR PROFESSIONAL USE ONLY OBSERVE ALL WARNINGS.
Read and understand all instruction manuals before operating equipment.
FLUID INJECTION HAZARD
General Safety
This pressure washer generates very high fluid pressure. Spray from the gun, leaks or ruptured components can inject fluid through your skin and into your body and cause extremely serious bodily injury including the need for amputation. Also, fluid injected or splashed into the eyes or on the skin can cause serious damage.
NEVERpoint the spray gun or wand at anyone or at any pan of the body. NEVER put hand or fingers over the spray tip.
ALWAYSfollow the Pressure Relief Procedure, before cleaning or servicing any part of the sprayer.
NEVER try to stop or deflect leaks with your hand or body.
Be sure equipment safety devices are operating properly before each use.
Pressure Relief Procedure
To reduce the risk of serious bodily injury, including fluid injection and splashing in the eyes, or on the skin, always follow this procedure whenever you stop spraying for more than 10 minutes, when shutting down, and before checking or repairing any part of the system.
1.Engage the trigger safety latch.
2.Turn the sprayer off.
3.Disconnect the electrical supply.
4.Shut off the water supply.
5.Disengage the trigger safety latch and trigger the gun to relieve pressure, and then engage the trigger safety latch again.
6.Before
Medical Treatment
If any fluid appears to penetrate your skin, qet
EMERGENCVMEDlCALTREATMENTATONCE.DO NOT TREAT AS A SIMPLE CUT.Tell the doctor exactly what fluid was injected.
NOTE TO PHYSICIAN: Injection in the skin is a ffaumafic injury. It is important to treat the injury surgically as soon as possible. Do not delay treatment to research toxicity. Toxicity is a concern with some exotic coatings injected directly into the bloodstream. Consultation with a plastic surgeon or reconstructive hand surgeon may be advisable.
Spray Gun Safety Devices
Be sure all gun safety devices are operating properly before each use. Do not remove or modify any pan of the gun; this can cause a malfunction and result in serious bodily injury.
SAFER LATCH: Whenever you stop spraying for a moment, always set the gun safety latch in the engaged or “safe” position, making the gun inoperative. Failure to properly set the safety latch can result in accidental triggering of the gun.
SPRAY TIP SAFETY: Use extreme caution when cleaning or changing spray tips. If a spray tip clogs while spraying, engage the gun safety latch immediately. ALWAYS follow the Pressure Reiief Procedure and then remove the spray tip to clean it.
2