INSTALLATION
CHECK FOR DAMAGE
Check unit for any damage that may have occurredin shipping. Any damageshouldbenotedandthe carrier notified immediately.
CONNECT TO WATER SUPPLY
Refer to Parts Drawing on page 9.
.. :'>, ,.. ' .,.. , ..'i
ELECTRICAL SERVICE |
| connection to water supply. | |
|
| ||
The 1020E model comeswith an electric starter box | Do not exceed16O0F(7O0C)watertemperaturetothe | ||
which isnotattachedtothe | unit. It is up tothe | ||
installertowirethemotortothestarterandthe | pump in a direct supply system. | ||
starter to the powersource. |
| Attach lidto tank by drilling four holesintank and use | |
The electrical service required for the1020E is 230V | |||
screws, bolts and washers provided. | |||
/6Ocycle / 50Amp / 3 phase. An optional 460V/ 60
cycle / 25 Amp / 3 phase service may be usedwith | Connectahosewithatleast3/4in.(ISmm)l.D.frOm | ||
special instructions from manufacturer. | your water supply to the 3/4 in. garden hose fitting | ||
| on the water tank. |
| |
Refer to instrucfion manual for the wiring diagram on |
| ||
page 4. Be sure that all wiring is properly grounded | Connect tank and pump with 3 / 4 in. I.D. hose and | ||
andaccordingtoalllocalandnationalelectrical | clamps provided with the unit. |
| |
codes. | Place one endof hose on hose barbbottomat | of water | |
INSTALL SPRAY GUN | |||
tank.Place theotherend of hose onhosebarb at | |||
| pump inlet. Clamp each end with,hose clamp. Pump | ||
Connect the spray hose to the spray gun by inserting module and water tankshouldbeasclose togetheras
the pin fitting at the end of the hose into the quick | possible.Amaximumdistance of 5 ft. isrecomm- |
coupler on the gun. | mended. |
|