Graco Inc 800-654, 2340 Installing and Changing Spray Tips, Follow the Pressure Relief Procedure

Page 9

Installing and Changing Spray Tips (2340)

WARNING

,

To reduce the risk of serious bodily injury

including fluid injection or splashing in the eyes or onto the skin, use extreme caution when

changing spray tips.

ALWAYS follow the

procedure below.

 

1.Follow the Pressure Relief Procedure.

2.Point the gun and wand away from yourself and anyone else.

3.Without holding your hand over the spray tip (A), pull back the quick coupler ring (B). Remove the old tip and/or install a new one, and then release the ring. See Figure 3.

4.Be sure the tip is secure before starting to spray again.

5.Tip holding holes are provided on the chassis.

CAUTION

To avoid blowing the o–ring out of the quick coupler, due to the high pressure in the system, never operate the pressure washer without a tip securely mounted in the quick coupler.

A

B

Figure 3

93￿8￿537

Page 8 Page 10
Image 9
Page 8 Page 10
Contents HYDRA-CLEAN1026, 1530 Pressure Washers Pressure Relief Procedure General SafetySpray Gun Safety Devices Medical TreatmentEquipment Misuse Hazard Hose SafetyFuel and Emission Hazards System PressureTerms Moving Parts HazardSet Up 1026 InstallationFor OnlyConnect to Water Supply Set UpStartup Chemical Injector Trigger Safety LatchFollow the Pressure Relief Procedure Installing and Changing Spray TipsSHUTDOWN, Flushing Storage MaintenanceProblem Troubleshooting ChartParts Drawing Part Description QTY Parts ListHydra-Cleanr2340 Pressure Washer Axle Pump and Unloader Assembly Crankcase Parts Drawing Parts List Pump Assembly, 2300 psi KIT Ring Valves Pump ServicePumping Section Servicing the PlungersTechnical Data AccessoriesChassis & Wheels Assembly 800-719 1026 Servicing the V-PackingsGraco Warranty Important Phone NumbersGraco INC. P.O. BOX 1441 MINNEAPOLIS, MN Parts Change Notice NEW
Top Page Image Contents