Graco Inc 308532S, 4043 Installing and Changing Spray Tips, Follow the Pressure Relief Procedure

Page 8

Operation

Installing and Changing Spray Tips

WARNING

To reduce risk of serious bodily injury, including fluid injection or splashing in eyes or onto skin, use extreme caution when changing spray tips. always follow procedure below.

1.Follow the Pressure Relief Procedure.

2.Point the gun and wand away from yourself and anyone else.

3.Without holding your hand over the spray tip (A), pull back the quick coupler ring (B). Remove the old tip and/or install a new one, and then release the ring. See Figure 3.

4.Be sure the tip is secure before starting to spray again.

5.Tip holding holes are provided on the chassis.

CAUTION

 

To avoid blowing o-ring out of quick coupler, due to

 

high pressure in system, never operate pressure

 

washer without tip securely mounted in quick

 

coupler.

04929

B

A

Figure 3

8308532

Image 8
Contents Instructions -- Parts List Important Safety InstructionsTable of Contents Hazardous Fluids Typical Installation -- Pressure Washer Component Identification and FunctionSetup Set UpCheck for Shipping Damage Connect to Water SupplyStartup Pressure Relief ProcedureOperation Trigger Safety Latch Trigger Safety Latch Shown Engaged aInstalling and Changing Spray Tips Follow the Pressure Relief ProcedureMaintenance Shutdown, Flushing, and StorageTroubleshooting Problem Cause SolutionService Equipment Misuse HazardPump Service DisassemblyReassembly Servicing the ValvesServicing Crankcase Section ReassemblyServicing the Seals and V-Packings 308532 Pressure Washer -- Parts SheetWheel & Tire Assembly Front LEG AssemblyBoot GUN & Wand AssemblyHydra-Clean 4043 Pressure Washer Sheet 2 308532 Pump Assembly -- Parts Manifold RingShim RetainerAccessories Downstream Chemical Injector KitUpstream Chemical Injector Kit Pressure Gauge KitTechnical Data ModelToll Free Graco WarrantyGraco Phone Number