Karcher T 200 manual Application, Cleaning horizontal surfaces, Cleaning vertical surfaces

Application

Note: Always use Kärcher water filter (order no. 4.730-059.0) during suction operations of the pressure washer.

Cleaning horizontal surfaces

Note: Outdoor surfaces should be swept before the T-Racer is used to avoid damaging the nozzles.

Connect the T-Racer and both wands with the trigger gun.

Illustration

ÎConnect lower wand with T-Racer.

1Press the bayonett connection into the bayonet catch, then turn by 90° until it locks into place.

2Tighten the union nut.

ÎConnect upper wand with lower wand.

1Press the bayonett connection into the bayonet catch, then turn by 90° until it locks into place.

2Tighten the union nut.

ÎConnect trigger gun with upper wand.

1Press the bayonett connection into the bayonet catch, then turn by 90° until it locks into place.

2Tighten the union nut.

Illustration

￿Caution

Do not run over freestanding corners.

Cleaning vertical surfaces

Connect the T-Racer and the lower wand with the trigger gun. Illustration

ÎConnect lower wand with T-Racer.

1Press the bayonett connection into the bayonet catch, then turn by 90° until it locks into place.

2Tighten the union nut.

ÎConnect trigger gun with lower wand.

1Press the bayonett connection into the bayonet catch, then turn by 90° until it locks into place.

2Tighten the union nut.

￿Caution

„Always hold the T-Racer at the hand grip while cleaning the walls.

„Do not reach under the edge of the T-Racer while the device is in opera- tion.

4English