IMPORTANT PRECAUTIONS – continued
Water Supply (Cold Water Only)
•Water hose must be at least a 1/2 inch or 5/8 inch in diameter.
•Flow rate of water supply must not fall below 2 GPM (gallons per minute).
•Flow rate can be determined by running the water for one minute into an empty
•The water supply temperature must not exceed 104°F/40°C.
•Never use the pressure washer to draw in water contaminated with solvents, e.g. paint thinners, gasoline, oil, etc.
NOTE: Dirt in the feed water will damage the unit. To avoid this risk, we recommend fitting a water filter.
•Always prevent debris from being drawn into the unit by using a clean water source and an accessory water filter if required.
ASSEMBLY INSTRUCTIONS
4
Step 1
Assemble the mobile adaptor by aligning the four holes to the machine. Tighten each of the four short screws provided.
Step 5 Assemble the detergent container.
Step 2
Slide the two handle posts into the mobile adaptor and line up the holes. Insert two of the long screws and tighten.
Step 6
Place the filter end of detergent suction tube into the detergent container.
Step 3
Insert wheels into side holes of the mobile adaptor and snap into place.
Step 7
Pull out the locking slide from the right side of the trigger gun handle.
Insert the small end of the high pressure hose into place.
Push the locking slide back into the trigger gun to lock the hose in position.
Step 4
Assemble the handle by aligning the holes to the handle posts.
Insert two of the long screws and tighten.