IMPORTANT PRECAUTIONS – continued
Water Supply (Cold Water Only)
•Water hose must be at least a 1/2 inch or 5/8 inch in diameter.
•Flow rate of water supply must not fall below 2 GPM (gallons per minute).
•Flow rate can be determined by running the water for one minute into an empty
•The water supply temperature must not exceed 104°F/40°C.
•Never use the pressure washer to draw in water contaminated with solvents, e.g. paint thinners, gasoline, oil, etc.
NOTE: Dirt in the feed water will damage the unit. To avoid this risk, we recommend fitting a water filter.
•Always prevent debris from being drawn into the unit by using a clean water source and an accessory water filter if required.
ASSEMBLY INSTRUCTIONS
4
Step 1
Attach the high pressure hose to the spray gun.
Step 2
Attach the wand to the spray gun.
Step 3
Attach the triple jet nozzle to the wand.