IMPORTANT PRECAUTIONS – continued
Water Supply
(Cold Water Only)
•Water hose must be at least 3/4 inch in diameter.
•Flow rate of water supply must not fall below 2.5 GPM (gallons per minute).
•Flow rate can be determined by running the water for one minute into an empty
•The water supply temperature must not exceed 104°F/40°C.
•Never use the pressure washer to draw in water contaminated with solvents, e.g. paint thinners, gasoline, oil, etc.
•Always prevent debris from being drawn into the unit by using a clean water source.
ASSEMBLY INSTRUCTIONS
3
Step 1 Insert the hook of the lower part of each wheel bracket into the slot located at the bottom of the unit, then slide the upper hook into the slot located at the top of the unit until it snaps into place.
Step 4 Pull out the locking slide from the right side of the trigger gun handle, and insert the small end of the high pressure hose into place. Push the locking slide back into the trigger gun to lock the hose in position.
Step 2 Slide the two han- dle posts into the wheel brackets and line up the holes. Insert each of the two long screws and tighten.
Step 5 Connect the detergent suction tube to the pressure washer.
Step 3 Slide the handle onto the two handle posts and line up the holes. Insert each of the two short screws and tighten.
Step 6 Insert the Spray Wand Extension into the trig- ger gun. Press in against the spring tension and twist into the lock position. Turn the Spray Wand Extension Collar clockwise until tight.