Do not use the appliance when there are other persons around unless they are also wearing safety equipment.
Wear protective clothing and safety goggles to protect against splash back containing water or dirt.
Caution
In case of extended downtimes, switch the appliance off at the main switch / ap- pliance switch or remove the mains plug.
Do not operate the appliance at temper- atures below 0 °C.
Observe a distance of at least 30 cm when using the jet to clean painted sur- faces to avoid damaging paintwork.
Never leave the appliance unattended when it is in operation.
Make sure that the power cable or ex- tension cables are not damaged by run- ning over, pinching, dragging or similar. Protect the power cable from heat, oil, and sharp edges.
All
The appliance may only be connected to an electrical supply which has been installed in accordance with IEC 60364.
The appliance may only be connected to alternating current. The voltage must correspond with the type plate on the appliance.
For safety reasons, we recommend that you operate the appliance only via a
30 mA).
Cleaning operations which produce oily waste water, e.g. engine washes, un- derbody washes, may only be carried out using washing stations equipped with an oil separator.
This appliance was designed to be used with detergents which are sup- plied or recommended by the manufac- turer. The use of other detergents or
chemicals may compromise the safety of the appliance.
Safety Devices
Caution
Safety devices protect the user and must not be modified or bypassed.
Power switch
The appliance switch prevents unintention- al operation of the appliance.
Lock trigger gun
This lock locks the lever of the trigger gun and prevents the inadvertent start of the ap- pliance.
Overflow valve with pressure switch
The overflow valve prevents the permissi- ble working pressure from being exceeded. If the lever on the trigger gun is released the pressure switch turns off the pump, the
Prerequisites for the appliance's
stability
Caution
Create stability for the appliance prior to all work on or with the appliance to prevent ac- cidents or damage.
–The stability of the appliance is warrant- ed when it is placed onto an even sur- face.
– 8