Euro-Pro VPW43 Operating Instructions Operating Instructionsructions, Garden Hose Connection

OPERATING INSTRUCTIONS

OPERATING INSTRUCTIONSRUCTIONS

Assembling the Pressure Washer Trolley (cont)

4.Slide the top brace over the legs and insert the handle assembly onto the top of the legs. Secure the handle assembly to the legs with two (2) of the 1/2-inch #8 Phillips screws provided. (Fig. 4)

Attaching High Pressure Hose to Pressure Washer

Once the pressure washer is assembled to the trolley, you are ready to use the unit.

1.While facing the front side of the unit attach the high pressure hose to the high pressure output connector on the right side of the unit. Twist on tight to avoid leakage. (Fig. 7)

Garden Hose Connection

Once all the desired attachments and the high pressure hose are attached to the pressure washer, you can connect the garden hose to the unit.

1.Attach the male adapter (supplied) to the water intake connector on the left hand side of the unit. (Fig. 9)

2.Attach the female hose coupling to the garden hose. (Fig. 9)

3.Connect the female hose coupling to the male adapter making sure that it is tightly secured in place. (Fig. 9)

CAUTION

When you wish to stop using the pressure washer temporarily, make sure that the safety lock has been engaged to avoid any accidental operation. (Fig. 10)

Safety

Fig. 4

5.Slide the top brace down the legs until it reaches the top of the pressure washer. Secure the top brace to the pressure washer unit with two (2) of the 1-inch #8 Phillips screws provided. (Fig. 5)

Fig. 5

6.When the unit is finally assembled, it should look like the illustration at the right. (Fig. 6)

Fig. 7

High pressure output fitting

2.Once the high pressure hose is connected to the main unit, you can attach any of the lances and accessories that you desire. To attach either of the lances or brush to the trigger gun, hold the trigger gun in your left hand insert the desired lance or brush and push it in all the way into the connector on the trigger gun and turn it clockwise 60° until it locks in place. To remove the attachment, push down on the attachment and turn counter- clockwise 60° and then pull out. Make sure that the attachments are securely locked in place before use. (Fig. 8)

Fig. 9

Low pressure water inlet

4. After all the connections have been

and BEFORE you plug the pressure

washer into an electrical outlet, open

the water supply and press on the

trigger switch in order to remove any

air which may be in the hose or

pump. Continue to press on the

trigger switch until you get a constant

flow of water coming out of the trigger

gun. Allow water to flow for 30

seconds.

5. Once this is accomplished, stop

pressing the trigger switch. Engage

the safety lock on the trigger

6. Ensure that the "On/Off" switch, at

the rear of the unit, is on the "Off"

position, then plug the unit into an

electrical outlet and turn the unit to

the "On" position.

7. Now you are ready to use the

pressure washer. Disengage the

Lock

Fig. 10

Using the Fan Jet Lance

When using the pressure washer with the fan jet lance to clean wood decks, siding vehicles, etc., always start using the fan spray and begin spraying from a minimum 36" away to avoid damaging the surface of the material that you are cleaning. Always clear the area that you will be cleaning of people, pets and objects.

Fig. 8

Fig. 6

5

safety lock and depress the trigger on

the trigger gun.

6