IMPORTANT PRECAUTIONS – continued
Water Supply
(Cold Water Only)
OPERATING INSTRUCTIONS
•Water hose must be at least 3/4 inch in diameter.
•Flow rate of water supply must not fall below 2.5 GPM (gallons per minute).
•Flow rate can be determined by running the water for one minute into an empty
•The water supply temperature must not exceed 104°F/40°C.
•Never use the pressure washer to draw in water contaminated with solvents, e.g. paint thinners, gasoline, oil, etc.
•Always prevent debris from being drawn into the unit by using a clean water source.
ASSEMBLY INSTRUCTIONS
Step 1 Connect the high pressure hose to | Step 2 Insert the spray wand of |
the unit’s high pressure outlet. | your choice into the wand extension. |
| Press in against the spring tension and |
| twist into the locked position. |
3
4
Step 1 Attach one adapter bracket to pressure washer by aligning holes on adapter bracket with posts on the pressure washer as shown. Tighten the two screws.
Step 3 Attach handle onto top of adapter brackets. Press down to lock.
Step 2 Place detergent reservoir between adapter brackets as shown. Attach second adapter bracket.
Step 3 Connect garden hose to unit’s water inlet.
Step 5 Plug the power cord into the power outlet. Trigger the gun to eliminate trapped air, wait for a steady flow of water to emerge from the spray nozzle.
Step 4 Connect garden hose to the cold water source and turn water on completely.
Step 6 Turn on the pressure washer (I). The motor starts only if the trigger of the gun is pulled and shuts off when the trigger is
Tighten with screws as shown.Step 4 Slide the spray wand extension
Note: Hose/cord caddy and trigger into the gun. Turn the wand collar onto the gun gun holder must be on opposite sides. threads until tight.