GFCI INSTRUCTIONS
WORKING WITH DETERGENTS
Detergents can only be applied at low pressure
Step 1 Plug the Ground Fault Circuit Interrupter (GFCI) into a working outlet.
Note:
The actual appearance of the GFCI may be different from this illustration.
Step 2 Press “TEST”, then press “RESET” to assure proper connection to power.
Step 1 Install the Vario spray wand.
For best results see Cleaning Tips on pages 8 & 9 for specific information on how to clean different surfaces.
USING THE ACCESSORIES
Vario spray wand
The Vario spray wand allows you to adjust the cleaning pressure. To clean at maximum pressure, the Vario wand must be positioned to the high pressure setting (+).
To apply detergent, the wand must be positioned to the low pressure setting
|
|
|
5 |
| For higher |
|
| |
|
| pressure turn |
|
| wand collar in the |
|
| plus (+) direction. |
|
| For lower |
|
| pressure turn |
|
| wand collar in the |
|
| minus |
|
|
|
Rotating spray wand
Set the Vario spray wand to the low pressure setting
Step 2 Fill the detergent reservoir with Cub Cadet detergent. Place the filter end of detergent suction tube into the detergent reservoir
Always Use Cub Cadet Detergents for Best Results.
Cub Cadet biodegradable detergents are specially formulated to protect the environment and your pressure washer. The special formula won’t clog the suction tube filter and will protect the internal parts of the pressure washer for a longer
life. For Cub Cadet Detergents, check 6 your retailer or call:
Dealer Referral Line
or visit our website: www.cubcadet.com
The following Cub Cadet detergents are available:
• Vehicle Wash | • Deck Wash |
Part # | Part # |
• Degreaser | • All Purpose Cleaner |
Part # | Part # |
This wand features a 0º pencil jet which rotates 360º for maximum dirt cutting action, effectively increasing cleaning performance up to 50%. This wand combines the cleaning performance of a 0º pencil jet with the surface coverage of a wide angle nozzle.
Not recommended for soft materials, siding, painted surfaces, decks or autos.
WARNING
TO AVOID SERIOUS INJURY,
NEVER POINT SPRAY NOZZLE
AT YOURSELF, OTHER PER-
SONS OR ANIMALS.
Step 3 Turn on the pressure washer. Pull trigger to operate unit: Liquid detergent is drawn into the unit and mixed with water. Apply detergent to work area. Do not allow detergent to dry on surface.
Caution
Never use:
•Bleach, Chlorine products and other corrosive chemicals
•Liquids containing solvents
(i.e., paint thinners, gasoline, oils)
•
•Ammonia products
•
These chemicals will harm the unit and will damage the surface being cleaned.