Assembly and Operating Instructions

NOTE: For additional references to the parts listed in the following pages, refer to the

Assembly Diagrams on pages 18 and 19.

To Set Up The Pressure Washer:

1.Attach the Spray Wand Extension (11A) to the Gun by inserting the tip of the Wand into the Gun Collar. Then push in firmly and rotate to secure the Wand to the Gun. (See Figure F.)

2.The Spray Wand (13A) and Detergent Bottle (34A) can be attached to the Spray Wand Extension (11A) in the same manner, by pushing in the accessory and rotating to secure the accessory to the Spray Wand Extension. (See Figure F.)

	SPRAY WAND EXTENSION		SPRAY WAND
		(11A)	(13A)
GUN

	GUN	COLLAR		DETERGENT BOTTLE





FIGURE F					(34A)

3.Remove the protective plastic caps from the unit’s water Inlet Port (17) and water Outlet Port (1). (See Figure G.)

4.Firmly attach the Garden Hose Adapter (58) to the water Inlet Port (17).

(See Figure G.)

5.Firmly attach the High Pressure Hose (55) to the water Outlet Port (1).

(See Figure G.)

OUTLET PORT (1)

HIGH PRESSURE HOSE (55)

INLET PORT (17)

GARDEN HOSE ADAPTER (58)

FIGURE G

SKU 92146

For technical questions, please call 1-800-444-3353.

PAGE 12