4.Assemble a "J" bolt through frame as shown (both side).
5.Slide handle onto "J" bolts and attach with knobs (both sides) . Tighten securely.
6.Feed end of chemical hose (without filter) through front panel and press onto barbed fitting of chemical injector.
7.Roll the unit off the carton and discard carton.
8.Connect high pressue hose to pump outlet.
9.Align tabs on accessory storage panel cover with holes in accessory storage panel and slide down until it locks into place.
10.Wind high pressure hose around hose reel of the accessory storage panel.
11.Connect wand to gun. Tighten securely.
9- ENG | A14687 |