UNPACKING
1.Open carton.
2.Remove plastic bag containing handle and engine manual supplied by engine manufacturer.
3.Remove cardboard from top of unit and inner cardboard from around unit.
4.Remove plastic bag containing two knobs, nozzle cleaning kit, instructional video, English Owner's Manual, and Spanish Owner's Manual from carton.
5.Remove spray gun,
6.Using box cutting tool, cut the four corners of the shipping carton from top to bottom, then lay panels flat. NOTE: Be careful not to cut into chemical hose and high pressure hose.
7.Insert handle ends into pressure washer frame as shown.
8.Install two knobs as shown in and tighten se- curely.
Knobs
9.Grasp handle and roll unit off of carton.
10.Remove high pressure hose from carton and store in gun/hose holder as shown in Pressure Washer Basics section in this manual.
ASSEMBLY
1.Connect threaded end of
2.Place assembled spray gun,
3.Add 30 weight engine oil (supplied) to engine. Refer to engine manual supplied by engine manu- facturer for procedure. Do not overfill. Use of a funnel is recommended.
NOTE
There will be a slight amount of oil in the engine from factory testing.
add oil
NOTE
The engine on this pressure washer is equipped with a low oil sensor. The amount of oil in the engine must be correct or the engine will not start.
NOTE
The DAPC pump on your pressure washer is filled with oil at the factory. There is no need to add oil at this time, see the Maintenance section of this manual to perform maintenance on this pump.
7 — ENG