OPERATION
WHEN USING THE HIGH PRESSURE SETTING, DO NOT ALLOW THE HIGH PRESSURE SPRAY TO COME IN CONTACT WITH UNPROTECTED SKIN, EYES, OR WITH ANY PETS OR ANIMALS. SERIOUS INJURY CAN OCCUR.
DO NOT stop spraying water for more than two minutes at a time. Pump operates in bypass mode when spray gun trigger is not pressed. If pump is left in bypass mode for more than two minutes internal components of the pump can be damaged.
DO NOT let hoses come in contact with very hot engine muffler during or immedi- ately after use of your pressure washer. Damage to hoses from contact with hot engine surfaces will NOT be covered by warranty.
6.Depress trigger on gun to start water flow. Release trigger to stop water flow.
Throttle Control
FAST
SLOW
STOP
4. Turn off water supply.
Never turn water supply off while pressure washer engine is running or damage to pump will result.
STAND ON A STABLE SURFACE AND GRIP GUN/WAND FIRMLY WITH BOTH HANDS. EXPECT THE GUN TO KICK WHEN TRIGGERED.
7.Adjust nozzle spray for the task being performed. See How To Use Wand instructions in the Opera- tion section.
SHUTTING DOWN YOUR PRESSURE WASHER
1.If you have siphoned chemicals or cleaners, you must siphon clean water through chemical hose to flush chemical injector.
2.Continue to siphon clean water through hose and pump for at least one minute before turning off engine.
NOTE
Failure to siphon clean water through chemical hose and pump after siphoning chemicals or cleaners can cause damage to pump.
3.Move throttle control to STOP position to stop engine.
DO NOT let hoses come in contact with very hot engine muffler during or immedi- ately after use of your pressure washer. Damage to hoses from contact with hot engine surfaces will NOT be covered by warranty.
5.Pull trigger on spray gun to relieve any water pressure in hose or spray gun.
6.Disconnect water supply hose from pump.
7.Coil high pressure hose and store in gun/hose holder.
8.Place spray gun in gun/hose holder.
9.Place chemical hose in gun/hose holder.
13 — ENG