Briggs & Stratton 020212-0 owner manual Preparing The Unit For Storage, Storing The Engine

Page 16

PREPARING THE UNIT FOR STORAGE

SpeedClean™ 2800 PSI Pressure Washer

PREPARING THE UNIT FOR STORAGE

Water should not remain in the unit for long periods of time. Sediments or minerals can deposit on pump parts and “freeze” pump action. If you do not plan to use the pressure washer for more than 30 days, follow this procedure:

1.Flush detergent siphoning tube by placing filter into a pail of clean water while running pressure washer in low pressure mode. Flush for one to two minutes.

2.Shut off engine and let it cool, then remove high pressure and garden hoses. Disconnect spark plug wire from spark plug.

3.Empty pump of liquids by pulling engine recoil handle about 6 times.This should remove most liquid in pump.

4.Use pump saver to prevent corrosion build up and freezing of pump.

5.Store unit in a clean, dry area.

Protecting the Pump

To protect the pump from damage caused by mineral deposits or freezing, use PumpSaver to treat pump.This prevents freeze damage and lubricates pistons and seals.

NOTE: PumpSaver is available as an optional accessory. It is not included with the pressure washer. Contact the nearest authorized service center to purchase PumpSaver.

To use PumpSaver, make sure the pressure washer is turned off and disconnected from supply water. Read and follow all instructions and warnings given on the PumpSaver container.

CAUTION

You must protect your unit from freezing temperatures.

•Failure to do so will permanently damage your pump and render your unit inoperable.

•Freeze damage is not covered under warranty.

CAUTION

Read and follow all cautions and warnings on the PumpSaver can label.

• Always wear eye protection when using PumpSaver.

CAUTION

PumpSaver will drip from pump after treatment and will stain wood and concrete.

• Protect surfaces from dripping PumpSaver.

NOTE: If PumpSaver is not available, draw RV antifreeze (non-alcohol) into the pump by pouring the solution into a 3-foot section of garden hose connected to inlet adapter and pulling recoil handle twice.

STORING THE ENGINE

See the engine owner’s manual for instructions on how to properly prepare the engine for storage.

16

Image 16

Contents BRIGGS & STRATTON POWER PRODUCTS GROUP, LLC JEFFERSON,WISCONSIN, U.S.ACall Pressure Washer Helpline 2800PSITABLE OF CONTENTS SAFETY RULESHazard Symbols and Meanings SAVE THESE INSTRUCTIONSFire or explosion can cause severe burns or death Severe burns can occur on contact KNOW YOUR PRESSURE WASHER ASSEMBLY Carton ContentsPREPARING PRESSURE WASHER FOR USE Remove Pressure Washer From CartonAdd Engine Oil and Fuel Connect Hose and Water Supply to PumpChecklist Before Starting Engine HOW TO USE YOUR PRESSURE WASHER How to Start Pressure WasherPressure Washer Location Pressure Washer ClearanceHow to Use Spray Tips How to Stop Your Pressure WasherFollow these instructions to change spray tips Cleaning and Applying Chemical Low PressureHigh Pressure IMPORTANT Use soaps designed specifically forCleaning Detergent Siphoning Tube Pressure Washer RinsingAutomatic Cool Down System Thermal ReliefSPECIFICATIONS GENERAL MAINTENANCE RECOMMENDATIONSPRESSURE WASHER MAINTENANCE Check and Clean Inlet ScreenNozzle Maintenance O-RingMaintenanceENGINE MAINTENANCE Pump MaintenanceChanging Pump Oil Change pump oil as followsSTORING THE ENGINE PREPARING THE UNIT FOR STORAGEProtecting the Pump TROUBLESHOOTING ProblemPump has following problems of pressure, low water volumeSpeedClean 2800 PSI Pressure Washer LIMITED WARRANTY WARRANTY PERIODABOUT YOUR WARRANTY OUR EQUIPMENTCONSERVE ESTAS INSTRUCCIONES TABLA DE CONTENIDOSDESCRIPCIÓN DEL EQUIPO REGLAS DE SEGURIDADCUANDO OPERE EL EQUIPO CUANDO AÑADA COMBUSTIBLECUANDO TRANSPORTE O REPARE EL EQUIPO PRECAUCIÓN CONOZCA SU MAQUINA LAVADORA DE PRESION MONTAJE PREPARANDO EL LAVADOR A PRESIÓN PARA SU USORemueva el Lavador a Presión del Empaque Contenido de la CajaAgregar Aceite al Motor y Gasolina Lista de Revision Previa al Arranque del Motor CÓMO USAR SU LAVADORA A PRESIÓN Ubicación del Lavadora a PresiónCómo Darle Arranque a su Lavadora a Presión Espacio Libre Alrededor del Lavadora a PresiónCómo Usar las Puntas de Rocío Cómo Parar su Lavador a PresiónPara cambiar las puntas de rocío La Presión Alta La Presión BajaLimpieza y Aplicación del Químico Limpiando el Tubo Enjuage de la Máquina Lavadora a PresiónSistema de Enfriamiento Automático Alivio Térmico ESPECIFICACIONES RECOMENDACIONES GENERALESMANTENIMIENTO DE LA MAQUINA LAVADORA A PRESION Antes de Cada UsoMantenimiento de la Boquilla Mantenimiento de los Anillos OMANTENIMIENTO DEL MOTOR Mantenimiento de la BombaCambio del aceite de la bomba Cambie el aceite como se indica a continuaciónALMACENANDO EL MOTOR PREPARANDO LA UNIDAD PARA SU ALMACENAMIENTOProteger la Bomba REPARACION DE AVERIAS Problemaproblemas no produce presión volumen de aguaGARANTÍA LIMITADA NUESTRO EQUIPOPERÍODO DE GARANTÍA ACERCA DE LA EQUIPO GARANTÍA