Add Engine Oil and Fuel

Generac Portable Products 3000 PSI Pressure Washer

4.Secure handle to pressure washer using four provided flange nuts.

5.Slowly tip pressure washer back in place and insert multi–colored spray tips in spaces provided in handle.

•Place pressure washer on a level surface.

•Refer to engine owner’s manual and follow oil and fuel recommendations and instructions.

Install Oil Dipstick on Pump

To install oil dipstick:

1.Make sure unit is on a level surface.

CAUTION

You MUST remove the pump’s shipping cap and install the oil dipstick.

•Failure to do so will void the warranty and damage the pump.

2.Remove and discard shipping cap located on pump (Figure 2).

Figure 2 — Install Oil Dipstick onto the Pump

Remove shipping cap and	Shipping Cap
install oil dipstick here.
Pump Oil
Dipstick

3.Install oil dipstick.

CAUTION

Any attempt to crank or start the engine before it has been properly filled with the recommended oil will result in equipment failure.

•Refer to engine manual for oil and fuel fill information.

•Damage to equipment resulting from failure to follow this instruction will void warranty.

NOTE: Check oil often during engine break–in. Refer to engine owner’s manual for recommendations.

Connect Hose and Water Supply to Pump

IMPORTANT: To avoid pump damage, you must assemble the nozzle extension to the spray gun and attach all hoses before you start the engine.

1.Uncoil high pressure hose and attach quick connect end of hose to base of spray gun (Figure 3). Pull down on collar of quick connect, slide onto spray gun and let go of collar. Tug on hose to be sure of a tight connection.

Figure 3 — Connect High Pressure Hose to Spray Gun

Connect high

pressure hose

here.

NOTE: Remove and discard all pump shipping caps before attaching hoses.